TPES65 Datasheet, PDF (1/2 Pages) Total Power International – ACCOMMODATE UNIVERSAL AC INPUT

TOTAL POWER INT'L
UNIVERSAL INPUT AC TO DC EXTERNAL DESKTOP ADAPTER
60-65 WATTS SINGLE OUTPUT SWITCHING POWER SUPPLIES
TPES65 SERIES
FEATURES:
ACCOMMODATE UNIVERSAL AC INPUT
DESKTOP IEC320-3P AC RECEPTACLE
MEET UNIVERSAL SAFETY STANDARDS
EMI MEET EN55022 / FCC CLASS B
CE MARKING COMPLIANCE
SPECIFICATION
INPUT SPECIFICATION
Input Voltage: 90-264Vac typical.
Input Connector: IEC320 3P-AC inlet receptacle.
Input Frequency: 47 ~ 63Hz.
Inrush Current: Less than 30A by adding thermister.
Input Current: 1.3A @115Vac./0.55A @230Vac typical.
Dielectric Withstand: Meet IEC950.
EMI: Meet EN55022 / FCC Class B.
Hold-up Time: 12mS @115Vac or
75mS @230Vac typical.
Over Temp. Protection (OTP): Optional.
Over Current Protection (OCP): Optional.
OUTPUT SPECIFICATION
Output Voltage: See Ratings Chart.
Output Current: See Ratings Chart.
Output Wattage: Typical 60 ~ 65W.
Output Connector & Cord: Optional.
Output LED Indicator: Installed.
Line Regulation: 0.1% typical.
Load Regulation: ±3.0 ~ 5.0% typical.
Noise & Ripple: Typ. 1.0% peak to peak.
OVP: Built-in, Zener Diode clamping.
Adjustability: Factory set, not available..
Overload Protection: Typ. 125-150% of max power
overrange or short circuit, power foldback
& self-recovering.
GENERAL SPECIFICATION
Efficiency: 80% ~ 86% typical.
Operating Temperature: 0 to +40°C.
Switching Frequency: Approximate 85K Hz.
Storage Temperature: -20 to +85°C.
Circuit Topology: Fixed Frequency Flyback circuit.
Temperature Coefficient: 0.04% /°C.
Transient Response: Output voltage returns in
Cooling: Free air convection.
less than 3mS following a 25% load change.
Construction: Impact resistant thermo-plastic
Safety Standard: UL1950/ EN60950 Class I.
enclosure case.
Power Density: 4.2 Watts. / Cubic Inch.
Desktop Format.
Notes: (1) All measurements are at nominal input, full load, and +25°C unless otherwise specified.
(2) Load regulation is measured at 115Vac or 230Vac in percentage to indicate the change in output voltage as the load is varied from half load to full load (±%).
(3) The typical cord length is about 1 meter (3.3 ft.), AWG#18 cord for various load conditions.