RSP-3000 Datasheet, PDF (1/6 Pages) Mean Well Enterprises Co., Ltd. – 3000W Single Output Power Supply

3000W Single Output Power Supply
RSP-3000 series
Features :
AC input 180 ~ 264VAC
AC input active surge current limiting
High efficiency up to 90%
Built-in active PFC function,PF>0.95
Protections: Short circuit / Overload / Over voltage / Over temperature
/ Fan alarm
Forced air cooling by built-in DC with fan speed control function
Output voltage can be trimmed between 20~110% of the rated output voltage
High power density 15.6W/inch³
Current sharing up to 3 units
Alarm signal output (relay contact and TTL signal)
Built-in 12V/0.1A auxiliary output for remote control
Built-in remote ON-OFF control
Built-in remote sense function
SPECIFICATION
3 years warranty
MODEL
RSP-3000-12
RSP-3000-24
RSP-3000-48
DC VOLTAGE
12V
24V
48V
RATED CURRENT
200A
125A
62.5A
CURRENT RANGE
0 ~ 200A
0 ~ 125A
0 ~ 62.5A
OUTPUT
RATED POWER
2400W
RIPPLE & NOISE (max.) Note.2 150mVp-p
VOLTAGE ADJ. RANGE
10.8 ~ 13.2V
VOLTAGE TOLERANCE Note.3 1.0%
LINE REGULATION
0.5%
3000W
150mVp-p
22 ~ 28V
1.0%
0.5%
3000W
200mVp-p
43 ~ 56V
1.0%
0.5%
LOAD REGULATION
0.5%
0.5%
0.5%
SETUP, RISE TIME
1000ms, 80ms at full load
HOLD UP TIME (Typ.)
10ms at full load
VOLTAGE RANGE
180 ~ 264VAC 254 ~ 370VDC
FREQUENCY RANGE
POWER FACTOR (Typ.)
47 ~ 63Hz
0.95/230VAC at full load
INPUT EFFICIENCY (Typ.)
86%
90%
90.5%
AC CURRENT (Typ.)
INRUSH CURRENT (Typ.)
20A/180VAC
60A/230VAC
16A/230VAC
LEAKAGE CURRENT
<2.0mA / 240VAC
OVERLOAD
100 ~ 112% rated output power
User adjustable continuous constant current limiting or constant current limiting with delay shutdown after 5 seconds, re-power on to recover
PROTECTION OVER VOLTAGE
13.8 ~ 16.8V
28.8 ~ 33.6V
Protection type : Shut down o/p voltage, re-power on to recover
57.6 ~ 67.2V
90 5 (12V), 110 5 (24V), 105 5 (48V) (TSW1: detect on heatsink of power transistor)
OVER TEMPERATURE
90 5 (12V), 85 5 (24V), 75 5 (48V) (TSW2 : detect on heatsink of o/p diode)
Protection type : Shut down o/p voltage, recovers automatically after temperature goes down
AUXILIARY POWER(AUX) ^{12V@0.1A(Only for Remote ON/OFF control)}
REMOTE ON/OFF CONTROL ^{Please see the Function Manual}
FUNCTION ALARM SIGNAL OUTPUT ^{Please see the Function Manual}
OUTPUT VOLTAGE TRIM 2.4 ~ 13.2V
4.8 ~ 28V
9.6 ~ 56V
CURRENT SHARING
Please see the Function Manual
WORKING TEMP.
-20 ~ +70 (Refer to output load derating curve)
WORKING HUMIDITY
20~90% RH non-condensing
ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +85 , 10 ~ 95% RH
TEMP. COEFFICIENT
0.05%/ (0 ~ 50 )
VIBRATION
10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes
SAFETY STANDARDS
UL60950-1, TUV EN60950-1 approved
SAFETY &
EMC
(Note 4)
WITHSTAND VOLTAGE
I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC
ISOLATION RESISTANCE I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH
EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22)
HARMONIC CURRENT
Compliance to EN61000-3-2,-3
OTHERS
NOTE
EMS IMMUNITY
Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, light industry level, criteria A
MTBF
104.5K hrs min. MIL-HDBK-217F (25 )
DIMENSION
278*177.8*63.5mm (L*W*H)
PACKING
4Kg; 4pcs/16Kg/1.89CUFT
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets
EMC directives.
File Name:RSP-3000-SPEC 2009-09-21