U1JC44TE12L Datasheet, PDF (2/4 Pages) Toshiba Semiconductor – Average Forward Current Repetitive Peak Reverse Voltage Mini Plastic Mold Package

STANDARD SOLDERING PAD
U1BC44,U1GC44,U1JC44
Handling Precaution
The absolute maximum ratings denote the absolute maximum ratings, which are rated values and must not be
exceeded during operation, even for an instant. The following are the general derating methods that we recommend
when you design a circuit with a device.
V_RRM:
We recommend that the worst case voltage, including surge voltage, be no greater than 80% of the
absolute maximum rating of V_RRM for a DC circuit and be no greater than 50% of that of V_RRM for
an AC circuit. V_RRM has a temperature coefficient of 0.1%/°C. Take this temperature coefficient into
account designing a device at low temperature.
I_F(AV): We recommend that the worst case current be no greater than 80% of the absolute maximum rating
of I_F(AV). Carry out adequate heat design. If you can’t design a circuit with excellent heat radiation,
set the margin by using an allowable Tamax-I_F(AV) curve.
This rating specifies the non-repetitive peak current in one cycle of a 50-Hz sine wave, condition angle 180.
Therefore, this is only applied for an abnormal operation, which seldom occurs during the lifespan of the device.
We recommend that a device be used at a Tj of below 120°C under the worst load and heat radiation conditions.
Thermal resistance between junction and ambient fluctuates depending on the device’s mounting condition. When
using a device, design a circuit board and a soldering land size to match the appropriate thermal resistance value.
Please refer to the Rectifiers databook for further information.
2
2006-11-06