English
Language : 

CLH02 Datasheet, PDF (2/5 Pages) Toshiba Semiconductor – Switching Mode Power Supply Applications
Marking
Abbreviation Code
H02
Part No.
CLH02
Standard Soldering Pad
5.9
Unit: mm
CLH02
1.8
2.6
4.8
Handling Precaution
1) The absolute maximum rating denotes the absolute maximum ratings, which are rated values that must not
be exceeded during operation, even for an instant. The following are the general derating methods that we
recommend for designing a circuit incorporating this device:
VRRM: Use this rating with reference to (1) above. The VRRM has a temperature coefficient of 0.1%/°C.
Take this temperature coefficient into account when designing a device at low temperature.
IF (AV): We recommend that the worst case current be no greater than 80% of the absolute maximum
rating of IF(AV) and that Tj be below 120°C.When using this device, take the margin into
consideration by using an allowable Ta (max)-IF (AV) curve.
IFSM: This rating specifies the non-repetitive peak current. This applies to abnormal operation only. When using
a device, design a circuit board and a soldering land size to match the appropriate thermal
resistance value.
IFSM: This rating specifies the non-repetitive peak current. This applies to abnormal operation only, When using
the device, design the circuit board and the soldering land size to match the appropriate thermal
resistance value.
Tj:
Derate this rating when using the device to ensure high reliability. We recommend that the device be
used at a Tj of below 120°C.
2) The thermal resistance between junction and ambient varies depending on the mounting condition of the
device. When using the device, design the circuit board and the soldering land size to match the appropriate
thermal resistance value.
3) See the Rectifiers databook for further information.
2
2006-11-08