|
TMP86C829BUG Datasheet, PDF (187/196 Pages) Toshiba Semiconductor – 8 Bit Microcontroller | |||
|
◁ |
TMP86C829BUG
17.3 DC Characteristics
Parameter
Symbol
Pins
Condition
Min
Hysteresis voltage
VHS
Hysteresis input
â
IIN1
TEST
Input current
IIN2
Sink open drain, Tri-state
port
VDD = 5.5 V, VIN = 5.5 V/0 V
â
IIN3
RESET, STOP
Input Resistance
RIN1
RIN2
TEST Pull-Down
RESET Pull-Up
VDD = 5.5 V, VIN = 5.5 V
â
VDD = 5.5 V, VIN = 0 V
100
Output leakage current
ILO
Sink open drain, Tri-state
port
VDD = 5.5 V, VOUT = 5.5 V/0 V
â
Output high voltage
VOH2
C-MOS, Tri-state port
VDD = 4.5 V, IOH = â0.7 mA
4.1
Output low voltage
VOL
Except XOUT and P3 port VDD = 4.5 V, IOL = 1.6 mA
â
Output low current
IOL
High current port (P3 port) VDD = 4.5 V, VOL = 1.0 V
â
Supply current in
NORMAL 1, 2 modes
Supply current in
IDLE 0, 1, 2 modes
VDD = 5.5 V
â
VIN = 5.3/0.2 V
fc = 16 MHz
fs = 32.768 kHz
â
Supply current in
SLOW 1 mode
Supply current in
IDD
SLEEP 1 mode
Supply current in
SLEEP 0 mode
â
VDD = 3.0 V
VIN = 2.8 V/0.2 V
â
fs = 32.768 kHz
â
Supply current in
STOP mode
VDD = 5.5 V
â
VIN = 5.3 V/0.2 V
(VSS = 0 V, Topr = â40 to 85°C)
Typ.
Max
Unit
0.9
â
V
â
±2
µA
70
â
kâ¦
220
450
â
±2
µA
â
â
V
â
0.4
20
â
7.5
9
mA
5.5
6.5
18
42
16
25
µA
12
20
0.5
10
Note 1: Typical values show those at Topr = 25°C, VDD = 5 V.
Note 2: Input current (IIN3): The current through pull-up resistor is not included.
Note 3: Input current (IIN1, IIN3): The current through pull-up or pull-down resistor is not included.
Note 4: IDD does not include IREF current.
Note 5: The supply currents of SLOW 2 and SLEEP 2 modes are equivalent to IDLE 0, 1, 2.
Page 173
|
▷ |