TC62D723FNG Datasheet, PDF (17/44 Pages) Toshiba Semiconductor – 16-Output constant current LED driver with the output gain control function and the PWM grayscale function

8-7-1) S6 command (Input of the state setting data (2).)
TC62D723FNG
Operation) In the number of SCK pulses at TRANS="H" is 15 or 16, the following operation is executed.
The state setting data (2) in the 16-bit shift register is transmitted to the state setting register.
Basic input pattern of S6 command)
8-7-2) Input form of the state setting data (2)
MSB
LSB
D15 D14 D13 D12 D11 D10 D9 D8 D7 D6 D5 D4 D3 D2 D1 D0
C0 D0 E0 F0 G0 I0 J0 K0 M0 N0 O0 -
-
-
-
-
D15 to D0 is serial-data-inputted at MSB first.
Please input "L" data to D4 to D0.
The state setting data (2) setting
Setting bit
Outline of command
Input data
0
1
C0
Setting of
thermal shutdown function (TSD)
Active
Not Active
Setting of
D0
PWMCLK open detection function
Active
Not Active
(POD)
Setting of
E0
output open detection function
Not Active
Active
(OOD)
Setting of
F0
output short detection function
Not Active
Active
(OSD)
G0
Setting of
PWM output synchronization
Synchronous Asynchronous
I0
Setting of
PWM output system
Normal output Division output
Setting of
J0
standby mode (2) function
This function becomes active only at
Not Active
Active
the time of the 16-bit PWM setting.
K0
Setting of
output short detection voltage
V_OSD1
V_OSD2
M0
Setting of
output delay function
Active
Not Active
N0
Setting of
SCK trigger of SOUT
Up edge
trigger mode
Down edge
trigger mode
O0
Setting of
PWM output mode
repeat mode One-shot mode
(Default)
Active
Active
Not Active
Not Active
Synchronous
Normal output
Not Active
V_OSD1
Active
Up edge
trigger mode
repeat mode
17
2012-01-30