English
Language : 

TMP86PM46NG Datasheet, PDF (156/170 Pages) Toshiba Semiconductor – 8 Bit Microcontroller
14. OTP operation
14.1 Operating mode
TMP86PM46NG
14.1.2.2 Program Writing using a General-purpose PROM Programmer
1. Recommended OTP adaptor
BM11188 for TMP86PM46NG
2. Setting of OTP adaptor
Set the switch (SW1) to "N" side.
3. Setting of PROM programmer
a. Set PROM type to TC571000D/AD.
Vpp: 12.75 V (high-speed program writing mode)
b. Data transmission ( or Copy) (Note 1)
The PROM of TMP86PM46NG is located on different address; it depends on operating
mode: MCU mode and PROM mode. When you write the data of ROM for mask ROM prod-
ucts, the data shuold be transferred (or copied ) from the address for MCU mode to that for
PROM mode before writing operation is executed. For the applicable program areas of MCU
mode and PROM mode are different, refer to TMP86PM46NG" Figure 14-1 Program Mem-
ory Area ".
Example: In the block transfer (copy) mode, executed as below.
32KB ROM capacity: 08000~0FFFFH → 00000~07FFFH
16KB ROM capacity: 0C000~0FFFFH → 04000~07FFFH
8KB ROM capacity : 0E000~0FFFFH → 06000~07FFFH
4KB ROM capacity : 0F000~0FFFFH → 07000~07FFFH
c. Setting of the program address (Note 1)
Start address: 0000H (When 16 KB ROM capacity, start address is 4000H.
When 8 KB ROM capacity, start address is 6000H.
When 4KB ROM capacity, start address is 7000H.)
End address: 7FFFH
4. Writting
Write and verify according to the above procedure "Setting of PROM programmer".
Note 1: For the setting method, refer to each description of PROM programmer.
Make sure to set the data of address area that is not in use to FFH.
Note 2: When setting MCU to the adaptor or when setting the adaptor to the PROM programmer, set the first
pin of the adaptor and that of PROM programmer socket matched. If the first pin is conversely set,
MCU or adaptor or programmer would be damaged.
Note 3: The TMP86PM46NG does not support the electric signature mode.
If PROM programmer uses the signature, the device would be damaged because of applying voltage
of 12±0.5V to pin 9(A9) of the address. Don’t use the signature.
Page 146