TLP714F Datasheet, PDF (1/15 Pages) Toshiba Semiconductor – Photocouplers GaAAs Infrared LED & Photo IC

Photocouplers GaAℓAs Infrared LED & Photo IC
TLP714F
TLP714F
1. Applications
• Intelligent Power Module Signal Isolation
• Factory Automation (FA)
• Transistor Inverters
2. General
The TLP714F is a photocoupler in a 6-pin SDIP package that consists of a GaAℓAs infrared light-emitting diode
(LED) optically coupled to an integrated high-gain, high-speed photodetector IC chip. It provides guaranteed
performance and specifications at temperatures up to 125.
The TLP714F is physically smaller than the one in an 8-pin DIP package and compliant with international safety
standards for reinforced insulation. It thus provides a smaller footprint solution for applications that require
safety standard certification. An internal noise shield provides a guaranteed commonmode transient immunity
of 20 kV/µs. The TLP714F guarantees minimum and maximum of propagation delay time, pulse width distortion.
Therefore it is suitable for isolation interface between IPM and control IC circuits in motor control application.
Leads of the TLP714F is bend to satisfy 8 mm PC board spacing requirements. Absolute maximum ratings and
electrical characteristics are the same as in the TLP714.
3. Features
(1) Inverter logic type (open collector output)
(2) Package: SDIP6
(3) Operating temperature: -40 to 125
(4) Supply voltage: -0.5 to 30 V
(5) Threshold input current: 5.0 mA (max)
(6) Supply current: 1.3 mA (max)
(7) Propagation delay time: t_pHL = 400 ns (max), t_pLH = 550 ns (max)
(8) Pulse width distortion: |t_pHL - t_pLH| = 400 ns (max)
(9) Common-mode transient immunity: ±20 kV/µs (min)
(10) Isolation voltage: 5000 Vrms (min)
(11) Safety standards
UL-approved: UL1577 File No.E67349
cUL-approved: CSA Component Acceptance Service No.5A, File No.E67349
VDE-approved: Option (D4) EN60747-5-2 (Note)
Note: When an EN60747-5-2 approved type is needed, please designate the Option (D4).
4. Packaging and Pin Configuration
11-5J101S
1
1: Anode
2: N.C.
3: Cathode
4: GND
5: V_O (Output)
6: V_CC
2012-09-16
Rev.3.0