TLP706F Datasheet, PDF (1/2 Pages) Toshiba Semiconductor – Intelligent power module signal isolation

TLP706F
TOSHIBA PHOTOCOUPLER GaAℓAs IRED & PHOTO-IC
TLP706F
Intelligent power module signal isolation
Industrial inverters
Motor drive
4.58±0.25
654
Unit in mm
The Toshiba TLP706F consists of a GaAℓAs light-emitting diode and an
integrated high-gain, high-speed photodetector. The TLP706F is suitable for
isolating input control signals to intelligent power modules. This unit is a 6-pin
SDIP. The TLP706F is 50% smaller than the 8-PIN DIP and meets the
reinforced insulation class requirements of international safety standards.
Therefore the mounting area can be reduced in equipment requiring safety
standard certification.
The detector has a totem pole output stage to provide both source and sink
driving.The detector IC has an internal shield that provides a guaranteed
common-mode transient immunity of 10 kV/μs.
The TLP706F is buffer logic type. For inverter logic type, the TLP702F is in
line-up.
Absolute Maxmum ratings and electrical characteristics are the same as
The TLP706 technical data sheets.
z Buffer logic type ( totem pole output )
z Pb Free
123
7.62±0.25
1.27±0.2
0.4±0.1
0.75±0.25
11.7±0.3
TOSHIBA
11-5J101
Weight：0.26 g (t yp .)
11-5J101
z Guaranteed performance over temperature : −40~100°C
z Power supply voltage : 4.5~20 V
z Input current: IFHL = 5 mA (max.)
z Switching time ( tpLH / tpHL) : 600 ns (max.)
z Common-mode transient immunity : ±10 kV/μs (min)
z Isolation voltage : 5000 Vrms (min)
z UL Recognized :UL1577, File No.E67349
z Option (D4)
TÜV Approved : DIN EN60747-5-2
No.R50033433
Maximum Operating Insulation Voltage : 1140V_PK
Highest Permissible Over Voltage
: 8000V_PK
(Note) : When a EN60747-5-2 approved type is needed,
Please designate “Option(D4)”
z Construction Mechanical Rating
Creepage Distance
Clearance
Insulation Thickness
8.0 mm (min)
8.0 mm (min)
0.4 mm (min)
Pin Configuration (Top View)
1
VCC ₆ ^1:ANODE
2:N.C.
2
5 ^3:CATHODE
4:GND
3
GND
SHIELD
4
5:Vo
6:Vcc
Schematic
I_F
1＋
VF
3－
I_CC
V_CC
6
Tr1
I_O
V_O
Tr2
5
Truth Table
Input
H
L
LED
ON
OFF
Tr1
ON
OFF
Tr2
OFF
ON
Output
H
L
SHIELD
0.1 μF bypass capacitor must be
connected between pins 6 and 4. (Note 4)
GND
4
1
2007-10-01