TC75S63TU Datasheet, PDF (1/9 Pages) Toshiba Semiconductor – Single Operational Amplifier (Low Noise Operational Amplifier)

TOSHIBA CMOS Linear Integrated Circuit Silicon Monolithic
TC75S63TU
Single Operational Amplifier (Low Noise Operational Amplifier)
TC75S63TU
Features
• Low Noise. VNI = 7.8nV/√Hz(typ.)@ VDD = 3.3 V
• Small Phase Delay. -2.5degrees@VDD = 3.3 V (typ.), f = 2kHz
• Low-current supply. 500μA @ VDD = 3.3 V (typ.)
• Ultra-compact package.
TC75S63TU
Absolute Maximum Ratings (Ta = 25°C)
Characteristics
Supply voltage
Differential input voltage
Input voltage
Output current
Power dissipation
Operating temperature
Storage temperature
Symbol
V_DD, V_SS
DV_IN
V_IN
I_OUT
P_D
T_opr
T_stg
Rating
6
±6
V_DD to V_SS
±4
450(Note1)
−40 to 85
−55 to 125
UFV
SON5-P-0202-0.65S
Weight: 7m g (typ.)
Unit
V
V
V
mA
mW
°C
°C
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if
the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum
ratings and the operating ranges.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test report
and estimated failure rate, etc).
Note1: Mounted on a glass epoxy circuit board of 30 mm × 30 mm. Pad dimension of 35mm²
Operating Ratings (Ta = 25°C)
Characteristics
Symbol
Rating
Unit
Supply voltage
V_DD, V_SS
2.2 to 5.5
V
Note2: Do not use this product in a voltage follower circuit or outside the range of the common mode input voltage.
(For the common mode input voltage, see DC Characteristics on Page 2). Failure to follow this instruction may
cause voltage oscillation.
:A higher load capacitance will increase the risk of voltage oscillation, even if this product is used within the range of the
common mode input voltage. Allow sufficient capacitance value margin when designing your circuit and using this
product to prevent voltage oscillation.
1
2012-03-14