TC74HC423AP_07 Datasheet, PDF (1/12 Pages) Toshiba Semiconductor – CMOS Digital Integrated Circuit Silicon Monolithic Dual Retriggerable Monostable Multivibrator

TC74HC423AP/AF
TOSHIBA CMOS Digital Integrated Circuit Silicon Monolithic
TC74HC423AP,TC74HC423AF
Dual Retriggerable Monostable Multivibrator
The TC74HC423A is a high speed CMOS MONOSTABLE
MULTIVIBRATOR fabricated with silicon gate C²MOS
technology.
It achieves the high speed operation similar to equivalent
LSTTL while maintaining the CMOS low power dissipation.
There are two trigger inputs, A input (negative edge), and B
input (positive edge). These inputs are valid for a slow rise/fall
time signal (tr = tf = 1 s) as they are schmitt trigger inputs.
After triggering, the output stays in a MONOSTABLE state for
a time period determined by the external resistor and capacitor
(Rx, Cx ). A low level at the CLR input breaks this state. In the
MONOSTABLE state, if a new trigger is applied, it extends the
MONOSTABLE period (retrigger mode).
Limitations for Cx and Rx are:
External capacitor, Cx: No limit
External resistor, Rx: V_CC = 2.0 V more than 5 kΩ
V_CC ≥ 3.0 V more than 1 kΩ
All inputs are equipped with protection circuits against static
discharge or transient excess voltage.
TC74HC423AP
TC74HC423AF
Features (Note)
• High speed: t_pd = 25 ns (typ.) at V_CC = 5 V
• Low power dissipation
Standby state: I_CC = 4 μA (max) at Ta = 25°C
Active state: I_CC = 700 μA (max) at V_CC = 5 V
• High noise immunity: V_NIH = V_NIL = 28% V_CC (min)
• Output drive capability: 10 LSTTL loads
• Symmetrical output impedance: |I_OH| = I_OL = 4 mA (min)
• Balanced propagation delays: t_pLH ^∼− t_pHL
• Wide operating voltage range: V_CC (opr) = 2~6 V
• Pin and function compatible with 74LS423
Weight
DIP16-P-300-2.54A
SOP16-P-300-1.27A
: 1.00 g (typ.)
: 0.18 g (typ.)
Note: In the case of using only one circuit, CLR should be tied to GND, Rx/Cxï½¥Cxï½¥Qï½¥ Q should be tied to
OPEN, the other inputs should be tied to V_CC or GND.
1
2007-10-01