LTD104C11S Datasheet, PDF (1/9 Pages) Toshiba Semiconductor – 26CM COLOUR TFT LCD MODULE

Toshiba Matsushita Display Technology Co., Ltd
PRODUCT INFORMATION
26cm COLOUR TFT-LCD MODULE
(10.4 TYPE)
LTD104C11S
(a-Si TFT)
All information is subject to change without notice. Please read bottom notes.
FEATURES:(1)10.4” VGA color display with High Luminance (400cd/m²)
(2)Wide Viewing Angle (Vertical:120, Horizontal:140)
(3)Built in Long Life Lamps (50,000 h)
TENTATIVE
MECHANICAL SPECIFICATIONS
Item
Dimensional Outline (typ.)
Number of Pixels
Active Area
Pixel Pitch
Weight (approximately)
Backlight
Specifications
238.5(W) x 177.5(H) x 12max(D) mm
640(W) x 480(H) pixels
211.2(W) x 158.4(H) mm
0.33(W) x 0.33(H)
500g
Twin CCFLs, Sidelight type
ABSOLUTE MAXIMUM RATINGS
Item
Min.
Max.
Supply Voltage ^(VDD)
-0.3
(VFL)
0
FL Driving Frequency (fFL)
---
Input Signal Voltage (VIN)
-0.3
Operating Temperature
(Note
-10
6.5
2.0
100
VDD+0.3
65
Storage Temperature
-20
80
Storage Humidity
(Max. wet bulb temperature = 39°C)
10
90
Note) Only operation is guarantied at Operating Temperature. Display quality is evaluated at +25°C.
Unit
V
kV(rms)
kHz
V
°C
°C
%(RH)
ELECTRICAL SPECIFICATION (Ta=25°C) (RECOMMENDED OPERATION CONDITION)
Item
Min.
Typ.
Max.
Unit
Remarks
(VDD)
4.75
5.0
5.25
V
VDD :5V
Supply Voltage
3.0
3.3
3.6
V
VDD :3.3V
FL Start Voltage
(VFL)
---
460
---
V(rms)
1200
---
1900 V(rms) Ta=-10°C
High Level Input Voltage (VIH)
0.7 VDD
---
VDD
Low Level Input Voltage (VIL)
0
---
0.3 VDD
V
Current Consumption
*¹ (IDD)
---
225
---
mA
*² (IFL)
3.0
6.0
6.5 mA(rms)
*1 *2 _{Power Consumption}
---
6.3
---
W
IFL =6.0mA(rms) VDD :3.3V
*1 : 8 color bars pattern
*2 : Except the efficiency of FL inverter
OPTICAL SPECIFICATION (Ta=25°C)
Item
Min.
Typ.
Max.
Unit
Remarks
Contrast Ratio (CR)
250
500
---
---
Viewing Angle (Upper+Lower)
---
120
---
°
(CR ≥ 10)
(Left+Right)
---
140
---
°
Response Time ^(τr)
(τf)
Luminance
Lamp Life Time (MTBF)*³ *⁴
---
---
50
---
---
50
---
400
---
50,000
ms
ms
cd/m²
h
IFL=6.0mA(rms)
*3 : Conditions ;Ta=25°C, IFL=6.0mA(rms), continuous lighting
*4 : Definitions of failure ; 1) Lcd luminance becomes half of the minimum value. 2) Lamp doesn’t light normally.
*The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by
Toshiba Matsushita Display Technology or other rights of the third parties which may result from its use. No license is granted by
implication or otherwise under any patent or patent rights of Toshiba Matsushita Display Technology or others.
*The information contained herein may be changed without prior notice. It is therefore advisable to contact Toshiba Matsushita Display
Technology before proceeding with the design of equipment incorporating this product.
(1/9)
2003-11-27 (Ver.0.4R)