TIBPAL22V10-20M_16 Datasheet, PDF (9/19 Pages) Texas Instruments – HIGH-PERFORMANCE IMPACT-X

Not Recommended For New Designs
TIBPAL22V10-20M
HIGH-PERFORMANCE IMPACT-X ™ PROGRAMMABLE ARRAY LOGIC CIRCUITS
SRPS012B − JUNE 1990 − REVISED APRIL 2010
electrical characteristics over recommended operating free-air temperature range
PARAMETER
TEST CONDITIONS
MIN TYP^† MAX UNIT
V_IK
V_OH
V_OL
I_OZH
I_OZL
I_I
I_IH
I_IL
CLK
All others
V_CC = 4.5 V,
V_CC = 4.5 V,
V_CC = 4.5 V,
V_CC = 5.5 V,
V_CC = 5.5 V,
V_CC = 5.5 V,
V_CC = 5.5 V,
V_CC = 5.5 V,
I_I = − 18 mA
I_OH = − 2 mA
I_OL = 12 mA
V_O = 2.7 V
V_O = 0.4 V
V_I = 5.5 V
V_I = 2.7 V
V_I = 0.4 V
−1.2 V
2.4 3.5
V
0.25 0.5 V
0.1 mA
−0.1 mA
1 mA
25 μA
− 0.2
mA
− 0.1
I_OS‡
V_CC = 5.5 V,
V_O = 0.5 V
− 30
−90 mA
I_CC
V_CC = 5.5 V,
V_I = GND,
Outputs open
200 mA
C_i
f = 1 MHz,
V_I = 2 V
5.5
pF
C_o
f = 1 MHz,
V_O = 2 V
8
pF
C_clk
f = 1 MHz,
V_CLK = 2 V
7
pF
† _{All typical values are at VCC = 5 V, TA = 25°C.}
‡ _{Not more than one output should be shorted at a time, and the duration of the short circuit should not exceed one second. VO is set at 0.5 V to}
avoid test problems caused by test equipment ground degradation.
switching characteristics over recommended ranges of supply voltage and operating free-air
temperature (unless otherwise noted)
PARAMETER
FROM
(INPUT)
TO
(OUTPUT)
TEST CONDITION
MIN
MAX
f_max§
t_pd
t_pd
t_pd
t_en
t_dis
External feedback
I, I/O
I/O
I, I/O (reset)
Q
CLK
Q
I, I/O
I/O, Q
I, I/O
I/O, Q
R1 = 390 Ω,
R2 = 750 Ω,
See Figure 4
33.3
20
25
15
20
20
§ _{fmax (with feedback) = tsu}
)
1
tpd(CLK
to
Q).Verification
of
t_su
and
t_pd(CLK
to
Q)
may
be
used
to
verify
expected
performance.
UNIT
MHz
ns
ns
ns
ns
ns
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
9