BQ20Z80ADBTR Datasheet, PDF (9/25 Pages) Texas Instruments – SBS 1.1-COMPLIANT GAS GAUGE ENABLED WITH IMPEDANCE TRACK

bq20z80
bq20z80A
www.ti.com
SLUS782 – JULY 2007
FEATURE SET (continued)
Gas Gauging
The bq20z80 uses the Impedance Track™ Technology to measure and calculate the available charge in battery
cells. The achievable accuracy is better than the coulomb counting method over the lifetime of the battery and
there is no full charge discharge learning cycle required.
See Theory and Implementation of Impedance Track Battery Fuel-Gauging Algorithm application note
(SLUA364) for further details.
LED Display
The bq20z80 can drive 3-, 4-, or 5- segment LED display for remaining capacity indication.
LifeTime Data Logging Features
The bq20z80 offers a lifetime data logging array, where all important measurements are stored for warranty and
analysis purposes. The data monitored includes:
• Lifetime maximum temperature
• Lifetime minimum temperature
• Lifetime maximum battery cell voltage
• Lifetime minimum battery cell voltage
• Lifetime maximum battery pack voltage
• Lifetime minimum battery pack voltage
• Lifetime maximum charge current
• Lifetime maximum discharge current
• Lifetime maximum charge power
• Lifetime maximum discharge power
• Lifetime maximum average discharge current
• Lifetime maximum average discharge power
• Lifetime average temperature
Authentication
The bq20z80 supports authentication by the host using SHA-1.
Power Modes
The bq20z80 supports 3 different power modes to reduce power consumption:
• In Normal Mode, the bq20z80 performs measurements, calculations, protection decision, data update in 1
second intervals. Between these intervals, the bq20z80 is in a reduced power stage.
• In Sleep Mode, the bq20z80 performs measurements, calculations, protection decision, data update in
adjustable time intervals. Between these intervals, the bq20z80 is in a reduced power stage.
• In Shutdown Mode the bq20z80 is completely disabled.
CONFIGURATION
Oscillator Function
The oscillator of the bq20z80 can be set up for internal or external operation. On power up, the bq20z80
automatically attempts to start the internal oscillator. If a 100-kΩ resistor is not connected to ROSC (pin 33),
then it attempts to start the oscillator using an external 32.768-kHz crystal.
NOTE
Install either the 100-kΩ ROSC resistor or the 12-pF, 32.768-kHz crystal. Do not
install both.
Submit Documentation Feedback
9