SM73306 Datasheet, PDF (6/22 Pages) Texas Instruments – SM73306 CMOS Rail-to-Rail Input and Output Operational Amplifier

AC Electrical Characteristics
Unless otherwise specified, all limits guaranteed for T_J = 25°C, V⁺ = 5V, V^− = 0V, V_CM = V_O = V⁺/2 and R_L > 1 MΩ. Boldface limits
apply at the temperature extremes
Symbol
Parameter
Conditions
Typ
(Note 5)
Limit (Note 6)
Units
SR
Slew Rate
(Note 9)
1.3
0.7
Vμs min
0.5
GBW Gain-Bandwidth Product V⁺ = 15V
1.5
MHz
φ_m
Phase Margin
50
Deg
G_m
Gain Margin
15
dB
Amp-to-Amp Isolation (Note 10)
150
dB
e_n
Input-Referred
F = 1 kHz
37
Voltage Noise
V_CM = 1V
i_n
Input-Referred
F = 1 kHz
0.06
Current Noise
T.H.D. Total Harmonic Distortion F = 1 kHz, A_V = −2
0.01
R_L = 10 kΩ, V_O = −4.1 V_PP
F = 10 kHz, A_V = −2
%
R_L = 10 kΩ, V_O = 8.5 V_PP
0.01
V⁺ = 10V
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is
intended to be functional, but specific performance is not guaranteed. For guaranteed specifications and the test conditions, see the Electrical Characteristics.
Note 2: Human body model, 1.5 kΩ in series with 100 pF.
Note 3: Applies to both single-supply and split-supply operation. Continuous short operation at elevated ambient temperature can result in exceeding the maximum
allowed junction temperature at 150°C. Output currents in excess of ±30 mA over long term may adversely affect reliability.
Note 4: The maximum power dissipation is a function of T_J(max), θ_JA and T_A. The maximum allowable power dissipation at any ambient temperature is P_D = (T_J
(max) ^{− T}A^)/θJA^{. All numbers apply for packages soldered directly into a PC board.}
Note 5: Typical Values represent the most likely parametric norm.
Note 6: All limits are guaranteed by testing or statistical analysis.
Note 7: V⁺ = 15V, V_CM = 7.5V and R_L connected to 7.5V. For Sourcing tests, 7.5V ≤ V_O ≤ 11.5V. For Sinking tests, 3.5V ≤ V_O ≤ 7.5V.
Note 8: Do not short circuit output to V⁺, when V⁺ is greater than 13V or reliability will be adversely affected.
Note 9: V⁺ = 15V. Connected as voltage follower with 10V step input. Number specified is the slower of the positive and negative slew rates.
Note 10: Input referred, V⁺ = 15V and R_L = 100 kΩ connected to 7.5V. Each amp excited in turn with 1 kHz to produce V_O = 12 V_PP.
Note 11: Guaranteed limits are dictated by tester limits and not device performance. Actual performance is reflected in the typical value.
5
www.national.com