DS92LV090A_14 Datasheet, PDF (6/16 Pages) Texas Instruments – 9 Channel Bus LVDS Transceiver

DS92LV090A
SNLS025D – APRIL 2000 – REVISED APRIL 2013
APPLICATIONS INFORMATION
www.ti.com
General application guidelines and hints may be found in the following application notes: AN-808 (SNLA028),
AN-903 (SNLA034), AN-971 (SNLA165), AN-977 (SNLA166), and AN-1108 (SNLA008).
There are a few common practices which should be implied when designing PCB for Bus LVDS signaling.
Recommended practices are:
• Use at least 4 PCB board layer (Bus LVDS signals, ground, power and TTL signals).
• Keep drivers and receivers as close to the (Bus LVDS port side) connector as possible.
• Bypass each Bus LVDS device and also use distributed bulk capacitance between power planes. Surface
mount capacitors placed close to power and ground pins work best. Two or three high frequency, multi-layer
ceramic (MLC) surface mount (0.1 µF, 0.01 µF, 0.001 µF) in parallel should be used between each V_CC and
ground. The capacitors should be as close as possible to the V_CC pin.
– Multiple vias should be used to connect V_CC and Ground planes to the pads of the by-pass capacitors.
– In addition, randomly distributed by-pass capacitors should be used.
• Use the termination resistor which best matches the differential impedance of your transmission line.
• Leave unused Bus LVDS receiver inputs open (floating). Limit traces on unused inputs to <0.5 inches.
• Isolate TTL signals from Bus LVDS signals
MEDIA (CONNECTOR or BACKPLANE) SELECTION:
• Use controlled impedance media. The backplane and connectors should have a matched differential
impedance.
Table 1. Functional Table
MODE SELECTED
DRIVER MODE
RECEIVER MODE
TRI-STATE MODE
LOOP BACK MODE
DE
RE
H
H
L
L
L
H
H
L
DE
H
H
H
L
RE
L
L
L
H
(1) X = High or Low logic state
L = Low state
Z = High impedance state
H = High state
Table 2. Transmitter Mode
INPUTS
D_IN
L
H
0.8V< D_IN <2.0V
X
Table 3. Receiver Mode⁽¹⁾
INPUTS
(RI+) – (RI−)
L (< −100 mV)
H (> +100 mV)
−100 mV < V_ID < +100 mV
X
DO+
L
H
X
Z
OUTPUTS
DO−
H
L
X
Z
OUTPUT
L
H
X
Z
6
Submit Documentation Feedback
Copyright © 2000–2013, Texas Instruments Incorporated
Product Folder Links: DS92LV090A