|
CC2510FX_16 Datasheet, PDF (6/245 Pages) Texas Instruments – Low-Power SoC (System-on-Chip) | |||
|
◁ |
CC2511F8 - Not Recommended for New Designs
2 Key Features (in more details)
2.1 High-Performance and Low-Power
8051-Compatible Microcontroller
⢠Optimized 8051 core which typically
gives 8x the performance of a standard
8051
⢠Two data pointers
⢠In-circuit interactive debugging is
supported by the IAR Embedded
Workbench through a simple two-wire
serial interface
⢠SW compatible with CC1110Fx/CC1111Fx
2.2 8/16/32 kB Non-volatile Program
Memory and 1/2/4 kB Data Memory
⢠8, 16, or 32 kB of non-volatile flash
memory, in-system programmable
through a simple two-wire interface or
by the 8051 core
⢠Minimum flash memory endurance:
1000 write/erase cycles
⢠Programmable read and write lock of
portions of flash memory for software
security
⢠1, 2, or 4 kB of internal SRAM
2.3 Full-Speed USB Controller (CC2511Fx )
⢠5 bi-directional endpoints in addition to
control endpoint 0
⢠Full-Speed, 12 Mbps transfer rate
⢠Support for Bulk, Interrupt, and
Isochronous endpoints
⢠1024 bytes of dedicated endpoint FIFO
memory
⢠8 - 512 byte data packet size supported
⢠Configurable FIFO size for IN and OUT
direction of endpoint
2.4 I2S Interface
⢠Industry standard I2S interface for
transfer of digital audio data
⢠Full duplex
⢠Mono and stereo support
⢠Configurable sample rate and sample
size
CC2510Fx / CC2511Fx
⢠Support for µ-law compression and
expansion
⢠Typically used to connect to external
DAC or ADC
2.5 Hardware AES Encryption/Decryption
⢠128-bit AES supported in hardware
coprocessor
2.6 Peripheral Features
⢠Powerful DMA Controller
⢠Power On Reset/Brown-Out Detection
⢠ADC with eight individual input
channels, single-ended or differential
(CC2511Fx has six channels) and
configurable resolution
⢠Programmable watchdog timer
⢠Five timers: one general 16-bit timer
with DSM mode, two general 8-bit
timers, one MAC timer, and one sleep
timer
⢠Two programmable USARTs for
master/slave SPI or UART operation
⢠21 configurable general-purpose digital
I/O-pins (CC2511Fx has 19)
⢠Random number generator
2.7 Low Power
⢠Four flexible power modes for reduced
power consumption
⢠System can wake up on external
interrupt or when the Sleep Timer
expires
⢠0.5 µA current consumption in PM2,
where external interrupts or the Sleep
Timer can wake up the system
⢠0.3 µA current consumption in PM3,
where external interrupts can wake up
the system
⢠Low-power fully static CMOS design
⢠System clock source is either a high
speed crystal oscillator (24 - 27 MHz for
CC2510Fx and 48 MHz for CC2511Fx) or a
high speed RC oscillator (12 - 13.5 MHz
for CC2510Fx and 12 MHz for CC2511Fx).
SWRS055G
Page 6 of 236
|
▷ |