LM3S1435 Datasheet, PDF (597/665 Pages) Texas Instruments – ARM and Thumb are registered trademarks and Cortex is a trademark

Stellaris^® LM3S1435 Microcontroller
Table 18-2. Signals by Signal Name (continued)
Pin Name
Pin Number Pin Type Buffer Type^a Description
U1Rx
12
I
TTL
UART module 1 receive. When in IrDA mode, this signal has
IrDA modulation.
U1Tx
13
O
TTL
UART module 1 transmit. When in IrDA mode, this signal has
IrDA modulation.
VBAT
55
-
Power Power source for the Hibernation module. It is normally
connected to the positive terminal of a battery and serves as
the battery backup/Hibernation module power-source supply.
VDD
8
-
Power Positive supply for I/O and some logic.
20
32
44
56
68
81
93
VDD25
14
-
Power Positive supply for most of the logic function, including the
38
processor core and most peripherals.
62
88
VDDA
3
-
Power The positive supply for the analog circuits (ADC, Analog
98
Comparators, etc.). These are separated from VDD to
minimize the electrical noise contained on VDD from affecting
the analog functions. VDDA pins must be supplied with a
voltage that meets the specification in “Recommended DC
Operating Conditions” on page 616, regardless of system
implementation.
WAKE
50
I
TTL
An external input that brings the processor out of Hibernate
mode when asserted.
XOSC0
52
I
Analog Hibernation module oscillator crystal input or an external clock
reference input. Note that this is either a crystal or a
32.768-kHz oscillator for the Hibernation module RTC.
XOSC1
53
O
Analog Hibernation module oscillator crystal output. Leave
unconnected when using a single-ended clock source.
a. The TTL designation indicates the pin has TTL-compatible voltage levels.
18.1.3 Signals by Function, Except for GPIO
Table 18-3. Signals by Function, Except for GPIO
Function
Pin Name
ADC
ADC0
ADC1
C0+
Analog Comparators C0-
C0o
CCP0
General-Purpose
Timers
CCP1
CCP2
CCP3
Pin Number
1
2
90
92
91
66
34
67
23
Pin Type
I
I
I
I
O
I/O
I/O
I/O
I/O
Buffer Type^a
Description
Analog Analog-to-digital converter input 0.
Analog Analog-to-digital converter input 1.
Analog Analog comparator 0 positive input.
Analog Analog comparator 0 negative input.
TTL
Analog comparator 0 output.
TTL
Capture/Compare/PWM 0.
TTL
Capture/Compare/PWM 1.
TTL
Capture/Compare/PWM 2.
TTL
Capture/Compare/PWM 3.
June 18, 2012
597
Texas Instruments-Production Data