LAUNCHXL-F28027 Datasheet, PDF (5/15 Pages) Texas Instruments – LAUNCHXL-F28027 C2000 Piccolo LaunchPad

www.ti.com
USB Connection
JTAG
Isolation
Jumpers:
JP1 and JP3
S4 Serial
Connection Switch
S1 Boot
Selection Switch
CPU Reset
Push Button
JTAG Emulator
Circuitry
Serial
TX/RX
LEDs
Installation
Jumper: JP2
20 PCB Pins
(doubled-sided male connectors)
Pre-Programmed C2000
Piccolo TMS320F28027
MCU
Programmable
Push Button:
GPIO12
Four LEDs
Figure 1. LAUNCHXL-F28027 Board Overview
1.2 Kit Contents
The LAUNCHXL-F28027 C2000 LaunchPad experimenter kit includes the following items:
• C2000 LaunchPad Board (LAUNCHXL-F28027)
• Mini USB-B Cable, 0.5m
• Quick Start Guide
1.3 Revisions
The first production revision of the LAUNCHXL-F28027 C2000 Piccolo LaunchPad, version 1.0, was
released in July of 2012 and is currently the only revision available.
2 Installation
The C2000 LaunchPad installation consists of three easy steps:
1. Download Code Composer Studio and controlSUITE™.
2. Install Code Composer Studio and controlSUITE.
3. Connect and install the C2000 LaunchPad to the PC.
Now the LaunchPad is ready to develop applications or run the pre-programmed demo.
2.1 Download the Required Software
Code Composer Studio IDE is available for free without any restriction when used with the XDS100
emulator on the C2000 LaunchPad. The software can be downloaded from the C2000 LaunchPad page at
www.ti.com/c2000-launchpad. At this site, you can also download a copy of controlSUITE that includes
drivers, examples, and other support software needed to get started.
SPRUHH2 – July 2012
Submit Documentation Feedback
LAUNCHXL-F28027 C2000 Piccolo LaunchPad Experimenter Kit
5
Copyright © 2012, Texas Instruments Incorporated