JM38510-10902BCA Datasheet, PDF (5/19 Pages) Texas Instruments – DUAL PRECISION TIMERS

www.ti.com
Operating Characteristics
V_CC = 5 V and 15 V
PARAMETER
TEST
CONDITIONS ⁽¹⁾
Initial error of timing
interval ⁽²⁾
Temperature
coefficient of timing
interval
Supply voltage
sensitivity of timing
interval
Each timer,
monostable ⁽³⁾
Each timer, astable⁽⁵⁾
Timer 1 – Timer 2
Each timer,
monostable ⁽³⁾
Each timer, astable⁽⁵⁾
Timer 1 – Timer 2
Each timer,
monostable ⁽³⁾
Each timer, astable⁽⁵⁾
Timer 1 – Timer 2
Output-pulse rise time
Output-pulse fall time
T_A = 25°C
T_A = MIN to MAX
T_A = 25°C
C_L = 15 pF,
T_A = 25°C
C_L = 15 pF,
T_A = 25°C
NA556, NE556, SA556, SE556
DUAL PRECISION TIMERS
SLFS023G – APRIL 1978 – REVISED JUNE 2006
NA556
NE556
SA556
MIN TYP
1
2.25%
±1
50
150
±10
0.1
0.3
±0.2
100
MAX
3
0.5
300
100
300
SE556
MIN TYP
0.5
1.5%
±0.5
30
90
±10
0.05
0.15
±0.1
100
UNIT
MAX
1.5 ⁽⁴⁾
100 ⁽⁴⁾
ppm/°C
0.2 ⁽⁴⁾
%/V
200⁽⁴⁾ ns
100 200⁽⁴⁾ ns
(1) For conditions shown as MIN or MAX, use the appropriate value specified under recommended operating conditions.
(2) Timing-interval error is defined as the difference between the measured value and the average value of a random sample from each
process run.
(3) Values specified are for a device in a monostable circuit similar to Figure 2, with the following component values: R_A = 2 kΩ to 100 kΩ,
C = 0.1 µF.
(4) On products compliant to MIL-PRF-38535, this parameter is not production tested.
(5) Values specified are for a device in an astable circuit similar to Figure 1, with the following component values: R_A = 1 kΩ to 100 kΩ,
C = 0.1 µF.
Submit Documentation Feedback
5