|
GD65232_16 Datasheet, PDF (5/23 Pages) Texas Instruments – MULTIPLE RS-232 DRIVERS AND RECEIVERS | |||
|
◁ |
Ä
GD65232, GD75232
MULTIPLE RSÄ232 DRIVERS AND RECEIVERS
Ä
SLLS206J â MAY 1995 â REVISED NOVEMBER 2004
DRIVER SECTION
electrical characteristics over recommended operating free-air temperature range, VDD = 9 V,
VSS = â9 V, VCC = 5 V (unless otherwise noted)
PARAMETER
TEST CONDITIONS
MIN TYP MAX UNIT
VOH
VOL
IIH
IIL
IOS(H)
High-level output voltage
Low-level output voltage (see Note 5)
High-level input current
Low-level input current
High-level short-circuit output current
(see Note 6)
VIL = 0.8 V,
VIH = 1.9 V,
VI = 5 V,
VI = 0,
VIL = 0.8 V,
RL = 3 kâ¦,
RL = 3 kâ¦,
See Figure 2
See Figure 2
VO = 0,
See Figure 1
See Figure 1
See Figure 1
6 7.5
V
â7.5
â6 V
10 µA
â1.6 mA
â4.5 â12 â19.5 mA
IOS(L) Low-level short-circuit output current VIH = 2 V,
VO = 0,
See Figure 1
4.5
12 19.5 mA
ro
Output resistance (see Note 7)
VCC = VDD = VSS = 0,
VO = â2 V to 2 V
300
â¦
NOTES:
5. The algebraic convention, where the more positive (less negative) limit is designated as maximum, is used in this data sheet for logic
levels only (e.g., if â10 V is maximum, the typical value is a more negative voltage).
6. Output short-circuit conditions must maintain the total power dissipation below absolute maximum ratings.
7. Test conditions are those specified by TIA/EIA-232-F and as listed above.
switching characteristics, VCC = 5 V, VDD = 12 V, VSS = â12 V, TA = 25°C
PARAMETER
TEST CONDITIONS
MIN TYP MAX UNIT
Propagation delay time,
tPLH low- to high-level output
RL = 3 k⦠to 7 kâ¦, CL = 15 pF,
See Figure 3
315 500 ns
tPHL
Propagation delay time,
high- to low-level output
RL = 3 k⦠to 7 kâ¦, CL = 15 pF,
See Figure 3
75 175 ns
Transition time,
tTLH low- to high-level output
RL = 3 k⦠to 7 kâ¦
CL = 15 pF,
CL = 2500 pF,
See Figure 3
See Figure 3 and Note 8
60 100 ns
1.7 2.5 µs
tTHL
Transition time,
high- to low-level output
RL = 3 k⦠to 7 kâ¦
CL = 15 pF,
CL = 2500 pF,
See Figure 3
See Figure 3 and Note 8
40
75 ns
1.5 2.5 µs
NOTE 8: Measured between ±3-V and ±3-V points of the output waveform (TIA/EIA-232-F conditions); all unused inputs are tied either high
or low.
⢠POST OFFICE BOX 655303 DALLAS, TEXAS 75265
5
|
▷ |