English
Language : 

SM320C6727B Datasheet, PDF (45/111 Pages) Texas Instruments – Floating-Point Digital Signal Processor
SM320C6727B
www.ti.com
SPRS861 – JANUARY 2014
4.11 External Memory Interface (EMIF)
4.11.1 EMIF Device-Specific Information
The C6727B DSP includes an external memory interface (EMIF) for optional SDRAM, NOR FLASH,
NAND FLASH, or SRAM. The key features of this EMIF are:
• One chip select (EM_CS[0]) dedicated for x16 and x32 SDRAM (x8 not supported)
• One chip select (EM_CS[2]) dedicated for x8, x16, or x32 NOR FLASH; x8, x16, or x32 Asynchronous
SRAM; or x8 or x16 NAND FLASH
• Data bus width is 32 bits on the C6727B.
• SDRAM burst length of 16 bytes
• External Wait Input on the C6727B through EM_WAIT (programmable active-high or active-low)
• External Wait pin functions as an interrupt for NAND Flash support
• NAND Flash logic calculates ECC on blocks of up to 512 bytes
• ECC logic suitable for single-bit errors
Figure 4-6 shows a typical example of EMIF-to-memory hookup on the C6727B DSP.
As the figures illustrate, the C6727B DSP includes a limited number of EMIF address lines. These are
sufficient to connect to SDRAM seamlessly. Asynchronous memory such as FLASH typically will need to
use additional GPIO pins to act as upper address lines during device boot up when the FLASH contents
are copied into SDRAM. (Normally, code is executed from SDRAM since SDRAM has faster access
times).
Any pins listed with a ‘Y' in the GPIO column of Table 2-12 may be used for this purpose, as long as it can
be assured that they be pulled low at (and after) reset and held low until configured as outputs by the
DSP.
Note that EM_BA[1:0] are used as low-order address lines for the asynchronous interface. For example, in
Figure 4-6, the flash memory is not byte-addressable and its A[0] input selects a 16-bit value. The
corresponding DSP address comes from EM_BA[1]. The remaining address lines from the DSP
(EM_A[12:0]) drive a word address into the flash inputs A[13:1].
Copyright © 2014, Texas Instruments Incorporated
Peripheral and Electrical Specifications
45
Submit Documentation Feedback
Product Folder Links: SM320C6727B