LM3S301 Datasheet, PDF (414/546 Pages) List of Unclassifed Manufacturers – Microcontroller

Synchronous Serial Interface (SSI)
■ Freescale SPI mode (SPO=1, SPH=1)
■ 1 Mbps bit rate
■ 8 data bits
Assuming the system clock is 20 MHz, the bit rate calculation would be:
FSSIClk = FSysClk / (CPSDVSR * (1 + SCR))
1x10⁶ = 20x10⁶ / (CPSDVSR * (1 + SCR))
In this case, if CPSDVSR=2, SCR must be 9.
The configuration sequence would be as follows:
1. Ensure that the SSE bit in the SSICR1 register is disabled.
2. Write the SSICR1 register with a value of 0x0000.0000.
3. Write the SSICPSR register with a value of 0x0000.0002.
4. Write the SSICR0 register with a value of 0x0000.09C7.
5. The SSI is then enabled by setting the SSE bit in the SSICR1 register to 1.
12.5
Register Map
Table 12-2 on page 414 lists the SSI registers. The offset listed is a hexadecimal increment to the
register’s address, relative to that SSI module’s base address:
■ SSI0: 0x4000.8000
Note that the SSI module clock must be enabled before the registers can be programmed (see
page 195). There must be a delay of 3 system clocks after the SSI module clock is enabled before
any SSI module registers are accessed.
Note: The SSI must be disabled (see the SSE bit in the SSICR1 register) before any of the control
registers are reprogrammed.
Table 12-2. SSI Register Map
Offset Name
Type
0x000 SSICR0
R/W
0x004 SSICR1
R/W
0x008 SSIDR
R/W
0x00C SSISR
RO
0x010 SSICPSR
R/W
0x014 SSIIM
R/W
0x018 SSIRIS
RO
0x01C SSIMIS
RO
Reset
0x0000.0000
0x0000.0000
0x0000.0000
0x0000.0003
0x0000.0000
0x0000.0000
0x0000.0008
0x0000.0000
Description
SSI Control 0
SSI Control 1
SSI Data
SSI Status
SSI Clock Prescale
SSI Interrupt Mask
SSI Raw Interrupt Status
SSI Masked Interrupt Status
See
page
416
418
420
421
423
424
426
427
414
July 14, 2014
Texas Instruments-Production Data