English
Language : 

TMDSPREX28335 Datasheet, PDF (4/5 Pages) Texas Instruments – Peripheral Explorer Kit Overview
Hardware Set Up
www.ti.com
3 Hardware Set Up
All the hardware needed to get started is included in this package. Since on-board emulation is available
using the USB, an external emulator is not needed, but suggested emulators are listed near the end of
this document. Install Code Composer Studio V3.3 or V4.1 before connecting the board to a PC.
Please follow these steps to set up the hardware:
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
Unpack the DIMM style controlCARD.
Spread open the winged retaining clips on connector J1.
Sit the DIMM card loosely in the connector slot. Make sure to align the two keyed notches
and position the card bottom corners inside the retaining clips (see the figure below).
Push vertically down using even pressure from both ends of the card until the clips snap and
lock. (Note: To remove or eject the card, simply spread open the retaining clips with thumbs).
Ensure switch 1 (SW1) is in the Off position and connect the USB cable.
Turn on the power and proceed.
4 Emulators
The following companies provide low cost, full featured emulators designed specifically for C2000™
controllers. However, an emulator is not required as the Peripheral Explorer has onboard USB JTAG
emulation.
Blackhawk™
http://www.blackhawk-dsp.com
Spectrum Digital
http://www.spectrumdigital.com
USB2000 Controller (part number
BH-USB-2000)
XDS510LC JTAG Emulator (part number
701902)
$299
$249
5 References
For more information, see the following guides:
• C2000 Teaching Materials – http://www.ti.com/lit/zip/ssqc019 provides detailed information on the
Peripheral Explorer projects
• TI University Homepage - www.ti.com/university provides additional university support and information
• PeripheralExplorer Tool Folder - http://focus.ti.com/docs/toolsw/folders/print/tmdsprex28335.html
C2000 is a trademark of Texas Instruments.
Blackhawk is a trademark of EWA Technologies, Inc.
4
Peripheral Explorer Kit Overview
SPRUGM2A – January 2009 – Revised June 2010
Copyright © 2009–2010, Texas Instruments Incorporated