LPV324M Datasheet, PDF (4/28 Pages) Texas Instruments – LPV321-N Single/LPV358 Dual/LPV324 Quad General Purpose, Low Voltage, Low Power,

LPV321, LPV324-N, LPV358-N
SNOS413D – AUGUST 2000 – REVISED MARCH 2013
www.ti.com
5V DC Electrical Characteristics (continued)
Unless otherwise specified, all limits specified for T_J = 25°C, V⁺ = 5V, V^− = 0V, V_CM = 2.0V, V_O = V⁺/2 and R _L > 1 MΩ.
Boldface limits apply at the temperature extremes.
Parameter
Test Conditions
Min ⁽¹⁾
Typ ⁽²⁾
Max ⁽¹⁾
Units
PSRR
Power Supply Rejection Ratio
2.7V ≤ V⁺ ≤ 5V
50
65
dB
V_O = 1V, V_CM = 1V
V_CM
Input Common-Mode Voltage
For CMRR ≥ 50 dB
Range
0
−0.2
V
4.2
4
A_V
Large Signal Voltage Gain
(3)
V_O
Output Swing
R_L = 100 kΩ
R_L = 100 kΩ to 2.5V
15
100
10
V/mV
V⁺ −100
V⁺ −3.5
V⁺ −200
mV
90
180
220
I_O
Output Short Circuit Current
LPV324, LPV358, and LPV321-N
2
16
Sourcing
V_O = 0V
Output Short Circuit Current Sinking LPV321-N
V_O = 5V
20
60
mA
LPV324 and LPV358
V_O = 5V
11
16
I_S
Supply Current
LPV321-N
9
12
15
LPV358
Both amplifiers
15
20
24
µA
LPV324
All four amplifiers
28
42
46
(3) R_L is connected to V ^-. The output voltage is 0.5V ≤ V_O ≤ 4.5V.
5V AC Electrical Characteristics
Unless otherwise specified, all limits specified for T_J = 25°C, V⁺ = 5V, V^− = 0V, V_CM = 2.0V, V_O = V⁺/2 and R _L > 1MΩ.
Boldface limits apply at the temperature extremes.
Parameter
SR
Slew Rate
Test Conditions
(3)
Min ⁽¹⁾
Typ ⁽²⁾
0.1
Min ⁽¹⁾
Units
V/µs
GBWP
Φ_m
G_m
e_n
i_n
Gain-Bandwidth Product
Phase Margin
Gain Margin
Input-Referred Voltage Noise
Input-Referred Current Noise
C_L = 22 pF
f = 1 kHz,
f = 1 kHz
152
kHz
87
Deg
19
dB
146
nV/√Hz
0.30
pA/√Hz
(1) All limits are specified by testing or statistical analysis.
(2) Typical values represent the most likely parametric norm as determined at the time of characterization. Actual typical values may vary
over time and will also depend on the application and configuration. The typical values are not tested and are not ensured on shipped
production material.
(3) Connected as voltage follower with 3V step input. Number specified is the slower of the positive and negative slew rates.
4
Submit Documentation Feedback
Copyright © 2000–2013, Texas Instruments Incorporated
Product Folder Links: LPV321 LPV324-N LPV358-N