LM3S316 Datasheet, PDF (372/588 Pages) List of Unclassifed Manufacturers – Microcontroller

Universal Asynchronous Receivers/Transmitters (UARTs)
11.3.5
The trigger points at which the FIFOs generate interrupts is controlled via the UART Interrupt FIFO
Level Select (UARTIFLS) register (see page 388). Both FIFOs can be individually configured to
trigger interrupts at different levels. Available configurations include 1/8, ¼, ½, ¾, and 7/8. For
example, if the ¼ option is selected for the receive FIFO, the UART generates a receive interrupt
after 4 data bytes are received. Out of reset, both FIFOs are configured to trigger an interrupt at the
½ mark.
Interrupts
The UART can generate interrupts when the following conditions are observed:
■ Overrun Error
■ Break Error
■ Parity Error
■ Framing Error
■ Receive Timeout
■ Transmit (when condition defined in the TXIFLSEL bit in the UARTIFLS register is met)
■ Receive (when condition defined in the RXIFLSEL bit in the UARTIFLS register is met)
All of the interrupt events are ORed together before being sent to the interrupt controller, so the
UART can only generate a single interrupt request to the controller at any given time. Software can
service multiple interrupt events in a single interrupt service routine by reading the UART Masked
Interrupt Status (UARTMIS) register (see page 393).
The interrupt events that can trigger a controller-level interrupt are defined in the UART Interrupt
Mask (UARTIM ) register (see page 390) by setting the corresponding IM bit to 1. If interrupts are
not used, the raw interrupt status is always visible via the UART Raw Interrupt Status (UARTRIS)
register (see page 392).
Interrupts are always cleared (for both the UARTMIS and UARTRIS registers) by setting the
corresponding bit in the UART Interrupt Clear (UARTICR) register (see page 394).
The receive interrupt changes state when one of the following events occurs:
■ If the FIFOs are enabled and the receive FIFO reaches the programmed trigger level, the RXRIS
bit is set. The receive interrupt is cleared by reading data from the receive FIFO until it becomes
less than the trigger level, or by clearing the interrupt by writing a 1 to the RXIC bit.
■ If the FIFOs are disabled (have a depth of one location) and data is received thereby filling the
location, the RXRIS bit is set. The receive interrupt is cleared by performing a single read of the
receive FIFO, or by clearing the interrupt by writing a 1 to the RXIC bit.
The transmit interrupt changes state when one of the following events occurs:
■ If the FIFOs are enabled and the transmit FIFO progresses through the programmed trigger
level, the TXRIS bit is set. The transmit interrupt is based on a transition through level, therefore
the FIFO must be written past the programmed trigger level otherwise no further transmit interrupts
will be generated. The transmit interrupt is cleared by writing data to the transmit FIFO until it
becomes greater than the trigger level, or by clearing the interrupt by writing a 1 to the TXIC bit.
372
July 14, 2014
Texas Instruments-Production Data