English
Language : 

LT1030C_14 Datasheet, PDF (3/15 Pages) Texas Instruments – QUADRUPLE LOW-POWER LINE DRIVER
LT1030C
QUADRUPLE LOW-POWER LINE DRIVER
SLLS048F – APRIL 1989 – REVISED APRIL 1998
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)†
Supply voltage range, VCC+ (see Note 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 V to 15 V
Supply voltage range, VCC– . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 V to –15 V
Input voltage range, logic inputs, VI . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . VCC– to 25 V
Input voltage range at ON/OFF, VI . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 V to 12 V
Output voltage range, VO (any output) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . VCC+ – 30 V to VCC– + 30 V
Duration of output short circuit to ±30 V at (or below) 25°C (see Note 2) . . . . . . . . . . . . . . . . . . . . . . . Unlimited
Package thermal impedance, θJA (see Note 3): D package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 127°C/W
N package . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 78°C/W
Storage temperature range, Tstg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –65°C to 150°C
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260°C
† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES:
1. All voltage values, except differential voltages, are with respect to GND.
2. The output may be shorted to either supply. Temperature and/or supply voltages must be limited to ensure that the maximum
dissipation rating is not exceeded.
3. The package thermal impedance is calculated in accordance with JESD 51, except for through-hole packages, which use a trace
length of zero.
recommended operating conditions
MIN
Supply voltage, VCC+
5
Supply voltage, VCC–
–5
High-level input voltage, VIH (see Note 4)
2
Low-level input voltage, VIL (see Note 4)
Operating free-air temperature, TA
0
NOTE 4: These VIH and VIL specifications apply only for inputs IN1–IN4. For operating levels for ON/OFF, see Figure 2.
MAX
15
–15
15
0.8
70
UNIT
V
V
V
V
°C
electrical characteristics over operating free-air temperature range, VCC± = ±5 V to ±15 V (unless
otherwise noted)
VOM+
VOM–
IIH
IIL
II
PARAMETER
Maximum positive peak output voltage swing
Maximum negative peak output voltage swing
High-level input current
Low-level input current
Input current, ON/OFF
IO
Output current
IOZ
Off-state output current
ICC
Supply current (all outputs low)
ICC(off) Off-state supply current
‡ All typical values are at VCC± = ±12 V, TA = 25°C.
TEST CONDITIONS
IO = –2 mA, TA = 25°C
IO = 2 mA, TA = 25°C
VI ≥ 2 V,
TA = 25°C
VI ≤ 0.8 V, TA = 25°C
VI = 0
VI = 5 V
TA = 25°C
VO = ±15 V, TA = 25°C,
ON/OFF at 0.4 V
VI ≥ at 2.4 V, IO = 0
ON/OFF at 0.4 V
ON/OFF at 0.1 V
MIN
VCC+–0.3
5
TYP‡
VCC+–0.1
VCC–+0.9
2
–10
–0.1
30
12
MAX
VCC–+1.4
20
–20
–10
65
UNIT
V
V
µA
µA
µA
mA
±2
±100
µA
500
1000
µA
10
µA
10
150
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
3