BQ500412 Datasheet, PDF (3/28 Pages) Texas Instruments – Low System Cost, Wireless Power Controller for WPC TX A6

bq500412
www.ti.com
RECOMMENDED OPERATING CONDITIONS
over operating free-air temperature range (unless otherwise noted)
V Supply voltage during operation, V33D, V33A
T_A Operating free-air temperature range
T_J Junction temperature
SLUSBO2A – NOVEMBER 2013 – REVISED DECEMBER 2013
MIN TYP MAX UNIT
3.0 3.3 3.6 V
–40
110
°C
110
THERMAL INFORMATION
θ_JA
θ_JCtop
θ_JB
ψ_JT
ψ_JB
θ_JCbot
THERMAL METRIC⁽¹⁾
Junction-to-ambient thermal resistance⁽²⁾
Junction-to-case (top) thermal resistance⁽³⁾
Junction-to-board thermal resistance⁽⁴⁾
Junction-to-top characterization parameter⁽⁵⁾
Junction-to-board characterization parameter⁽⁶⁾
Junction-to-case (bottom) thermal resistance⁽⁷⁾
bq500412
RGZ
48 PINS
28.4
14.2
5.4
0.2
5.3
1.4
UNITS
°C/W
(1) For more information about traditional and new thermal metrics, see the IC Package Thermal Metrics application report, SPRA953.
(2) The junction-to-ambient thermal resistance under natural convection is obtained in a simulation on a JEDEC-standard, high-K board, as
specified in JESD51-7, in an environment described in JESD51-2a.
(3) The junction-to-case (top) thermal resistance is obtained by simulating a cold plate test on the package top. No specific JEDEC-
standard test exists, but a close description can be found in the ANSI SEMI standard G30-88.
(4) The junction-to-board thermal resistance is obtained by simulating in an environment with a ring cold plate fixture to control the PCB
temperature, as described in JESD51-8.
(5) The junction-to-top characterization parameter, ψ_JT, estimates the junction temperature of a device in a real system and is extracted
from the simulation data for obtaining θ_JA, using a procedure described in JESD51-2a (sections 6 and 7).
(6) The junction-to-board characterization parameter, ψ_JB, estimates the junction temperature of a device in a real system and is extracted
from the simulation data for obtaining θ_JA , using a procedure described in JESD51-2a (sections 6 and 7).
(7) The junction-to-case (bottom) thermal resistance is obtained by simulating a cold plate test on the exposed (power) pad. No specific
JEDEC standard test exists, but a close description can be found in the ANSI SEMI standard G30-88.
Spacer
Copyright © 2013, Texas Instruments Incorporated
Product Folder Links: bq500412
Submit Documentation Feedback
3