ADS930_14 Datasheet, PDF (3/16 Pages) Texas Instruments – 8-Bit, 30MHz Sampling ANALOG-TO-DIGITAL CONVERTER

ELECTRICAL CHARACTERISTICS (Cont.)
At T_A = +25°C, V_S = +3V, Single-ended Input and Sampling Rate = 30MHz, unless otherwise specified.
ADS930E
PARAMETER
CONDITIONS
TEMP
MIN
TYP
MAX
UNITS
Differential Gain Error
Differential Phase Error
Output Noise
Aperture Delay Time
Aperture Jitter
Analog Input Bandwidth
Small Signal
Full Power
Overvoltage Recovery Time⁽⁴⁾
DIGITAL OUTPUTS
Logic Family
Logic Coding
High Output Voltage, V_OH
Low Output Voltage, V_OL
3-State Enable Time
3-State Disable Time
Internal Pull-Down
Power-Down Enable Time
Power-Down Disable Time
Internal Pull-Down
ACCURACY
Gain Error
Input Offset
Power Supply Rejection (Gain)
Power Supply Rejection (Offset)
Internal Positive Reference Voltage
Internal Negative Reference Voltage
POWER SUPPLY REQUIREMENTS
Supply Voltage: +V_S
Supply Current: +I_S
Power Dissipation
Power Dissipation (Power Down)
Thermal Resistance, θ_JA
SSOP-28
NTSC, PAL
NTSC, PAL
Input Grounded
2.3
%
1
degrees
0.2
LSBs rms
2
ns
7
ps rms
–20dBFS Input
0dBFS Input
350
MHz
100
MHz
2
ns
C_L = 15pF
OE = L
OE = H
PwrDn = L
PwrDn = H
TTL/HCT Compatible CMOS
Straight Offset Binary
+2.4
LV_DD
V
0.4
V
20
40
ns
2
10
ns
50
kΩ
133
ns
18
ns
50
kΩ
f_S = 2.5MHz
Full
Referred to Ideal Midscale
Full
∆ V_S = +10%
Full
Full
Full
Full
5.9
±10
56
56
+1.75
+1.25
10
%FS
±60
mV
dB
dB
V
V
Operating
Operating, +3V
Operating, +3V
Operating, +5V
Operating, +3V
Operating, +5V
Full
+2.7
+3.0
+5.25
V
Full
22
mA
Full
66
84
mW
Full
168
mW
Full
10
mW
Full
15
mW
89
°C/W
NOTES: (1) Spurious Free Dynamic Range refers to the magnitude of the largest harmonic. (2) dBFS means dB relative to full scale. (3) Two-tone intermodulation
distortion is referred to the largest fundamental tone. This number will be 6dB higher if it is referred to the magnitude of the two-tone fundamental envelope. (4) No
“Rollover” of bits.
ADS930
3
SBAS059A