TSC2017_14 Datasheet, PDF (27/39 Pages) Texas Instruments – 12-Bit, Nanopower, 4-Wire Micro TOUCH SCREEN CONTROLLER with I2C™ Interface

TSC2017
www.ti.com
SBAS472 – DECEMBER 2009
READ A CONVERSION/READ CYCLE
For best performance, the I²C bus should remain in an idle state while an A/D conversion is taking place. This
idling prevents digital clock noise from affecting the bit decisions being made by the TSC2017. The master
should wait for at least 10μs before attempting to read data from the TSC2017 to realize this best performance.
However, the master does not need to wait for a completed conversion before beginning a read from the slave, if
full 12-bit performance is not necessary.
Data access begins with the master issuing a START condition followed by the address byte (see Table 1) with
R/W = 1.
When the eighth bit has been received and the address matches, the slave issues an acknowledge. The first
byte of serial data then follows (D11-D4, MSB first).
After the first byte has been sent by the slave, it releases the SDA line for the master to issue an acknowledge.
The slave responds with the second byte of serial data upon receiving the acknowledge from the master (D3-D0,
followed by four 0 bits). The second byte is followed by a NOT acknowledge bit (ACK = 1) from the master to
indicate that the last data byte has been received. If the master somehow acknowledges the second data byte,
invalid data are returned (FFh). This condition applies to both 12-and 8-bit modes. See Figure 32 for a complete
I²C read transmission.
SCL
Address Byte
Data Byte 1
Data Byte 2
SDA
1 0 0 1 0 0 A0 R/W 0 D11 D10 D9 D8 D7 D6 D5 D4 0 D3 D2 D1 D0 0 0 0 0 1
1
START
TSC2017
ACK
MASTER
ACK
Figure 32. Complete I²C Serial Read Transmission
MASTER STOP or
NACK Repeated
START
Copyright © 2009, Texas Instruments Incorporated
Product Folder Link(s): TSC2017
Submit Documentation Feedback
27