RI-TRP-RR3P-30_13 Datasheet, PDF (2/3 Pages) Texas Instruments – 23mm GLASS TRANSPONDER

RI-TRP-RR3P-30 is OBSOLETE
RI-TRP-RR3P-30, RI-TRP-WR3P-30
SCBS843 – SEPTEMBER 2001
www.ti.com
OPERATING CHARACTERISTICS
over operating free-air temperature range (unless otherwise noted)
PARAMETER
Functionality
Memory (Bits)
Memory (Pages)
Operating Frequency
Modulation
Transmission Principle
Power Source
Typical Reading Range
Typical Programming Range
Typical Reading Time
Typical Programming Time
Typical Programming Cycles
Case Material
Protection Class
EMC
Signal Penetration
Mechanical Shock
Vibration
Dimensions
Weight
PART NUMBER
RI-TRP-RR3P
RI-TRP-WR3P
Read Only
Read/Write
64
80 ⁽¹⁾
1
1
134.2
FSK (Frequency Shift Keying) 134.2 kHz / 123.2 kHz
HDX (Half Duplex)
Powered from the reader signal (batteryless)
≤ 60⁽²⁾
—
30% of specified reading range
70
—
309
—
100,000
Glass
Hermetically sealed
Programmed code is not affected by normal electromagnetic interference or
x-rays
Transponder can be read through virtually all non-metallic material
IEC 68-2-27, Test Ea; 300 g, half sine, 3 ms, 2 axes
IEC 68-2-6, Test Fc; 3 g, 5 – 50 Hz, 2 axes, 24 hours per axis
20 g, 10 – 2000 Hz, 2 axes, 2.5 hours per axis
Ø3.85 mm ± 0.05 mm × 23.1 mm ± 0.5 mm
0.6
UNIT
kHz
cm
ms
ms
g
(1) We recommend that you split each 80 bit page into 64 user programmable bits plus a 16 bit wide CRC CCITT Block Check Character as
is done by TI-RFid™ LF readers.
(2) Depending on RF regulation in country of use, the Reader Antenna configuration used, and the environmental conditions.
2
Submit Documentation Feedback