OPA361-Q1 Datasheet, PDF (2/18 Pages) Texas Instruments – 3V Video Amplifier with Internal Gain and Filter in SC70

OPA361-Q1
SBOS552 – MARCH 2011
www.ti.com
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam
during storage or handling to prevent electrostatic damage to the MOS gates.
PRODUCT
OPA361-Q1
ORDERING INFORMATION⁽¹⁾
PACKAGE
PACKAGE DESIGNATOR
SC70-6
DCK
PACKAGE MARKING
QXP
(1) For the most current package and ordering information, see the Package Option Addendum at the end of this datasheet, or see the TI
website at www.ti.com.
PIN CONFIGURATION
DCK PACKAGE
(TOP VIEW)
+In 1
GND 2
R_SET 3
6 V+
5 Enable
4 Out
The location of pin 1 on the OPA361-Q1 is determined by orienting the package marking as shown in the diagram
above.
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
Supply voltage, V+ to V–
Signal input terminals
Voltage ⁽²⁾
Current ⁽²⁾
Output short-circuit through 75Ω to GND⁽³⁾
Operating temperature
Storage temperature
Junction temperature
VALUE
+3.6
–0.5 to (V+) + 0.5
±10
Continuous
–40 to +125
–65 to +150
+160
UNIT
V
V
mA
°C
°C
°C
(1) Stresses above these ratings may cause permanent damage. Exposure to absolute maximum conditions for extended periods may
degrade device reliability. These are stress ratings only, and functional operation of the device at these or any other conditions beyond
those specified is not implied.
(2) Input terminals are diode-clamped to the power-supply rails. Input signals that can swing more than 0.5V beyond the supply rails should
be current-limited to 10mA or less.
(3) Short-circuit to ground.
2
Submit Documentation Feedback
Product Folder Link(s) :OPA361-Q1
Copyright © 2011, Texas Instruments Incorporated