OPA360 Datasheet, PDF (2/24 Pages) Burr-Brown (TI) – 3V Video Amplifier with 6dB Gain and Filter in SC70

OPA360
SB0S294E − DECEMBER 2003 − REVISED SEPTEMBER 2006
www.ti.com
ORDERING INFORMATION⁽¹⁾
PRODUCT
PACKAGE
PACKAGE DESIGNATOR
PACKAGE MARKING
OPA360
SC70-6
DCK
AUW
(1) _{For the most current package and ordering information see the Package Option Addendum at at the end of this document, or see the TI web}
site at www.ti.com.
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
Supply Voltage, V+ to V− . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +3.6V
Signal Input Terminals, Voltage(2) . . . . (V−) −0.5V to (V+) + 0.5V
Current(2) . . . . . . . . . . . . . . . . . . . ±10mA
Output Short-Circuit through 75Ω to GND(3) . . . . . . . Continuous
Operating Temperature . . . . . . . . . . . . . . . . . . . . . . −40°C to +85°C
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . −65°C to +150°C
Junction Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +160°C
(1) _{Stresses above these ratings may cause permanent damage.}
Exposure to absolute maximum conditions for extended periods
may degrade device reliability. These are stress ratings only, and
functional operation of the device at these or any other conditions
beyond those specified is not implied.
(2) _{Input terminals are diode-clamped to the power-supply rails.}
Input signals that can swing more than 0.5V beyond the supply
rails should be current-limited to 10mA or less.
(3) _{Short-circuit to ground.}
This integrated circuit can be damaged by ESD. Texas
Instruments recommends that all integrated circuits be
handled with appropriate precautions. Failure to observe
proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to
complete device failure. Precision integrated circuits may be more
susceptible to damage because very small parametric changes could
cause the device not to meet its published specifications.
PIN CONFIGURATION
OPA360
+In 1 LPF
GND 2
SAG 3
6 V+
5 Enable
4 Out
SC70−6⁽¹⁾
(1) _{Pin 1 of the SC70-6 is determined by orienting}
the package marking as indicated in the diagram.
2