OPA336NA3K Datasheet, PDF (2/24 Pages) Texas Instruments – SINGLE-SUPPLY, microPower CMOS OPERATIONAL AMPLIFIERS microAmplifier ™ Series

PACKAGE/ORDERING INFORMATION⁽¹⁾
PRODUCT
Single
OPA336N
OPA336NA
OPA336NJ
OPA336U
OPA336UA
OPA336UJ
Dual
OPA2336E
OPA2336EA
OPA2336P
OPA2336PA
OPA2336U
OPA2336UA
Quad
OPA4336EA
PACKAGE-LEAD
SOT23-5
SOT23-5
SOT23-5
SO-8 Surface-Mount
SO-8 Surface-Mount
SO-8 Surface-Mount
MSOP-8 Surface-Mount
MSOP-8 Surface-Mount
DIP-8
DIP-8
SO-8 Surface-Mount
SO-8 Surface-Mount
SSOP-16 Surface-Mount
PACKAGE
DRAWING
DESIGNATOR
DBV
DBV
DBV
D
D
D
DGK
DGK
P
P
D
D
DBQ
PACKAGE
MARKING
A36⁽²⁾
A36⁽²⁾
J36
OPA336U
OPA336UA
OPA336UJ
B36⁽²⁾
B36⁽²⁾
OPA2336P
OPA2336PA
OPA2336U
OPA2336UA
OPA4336EA
NOTES: (1) For the most current package and ordering information, see the package option addendum at the end of this data sheet. (2) Grade will be marked on
the Reel.
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
Supply Voltage ................................................................................... 7.5V
Signal Input Terminals, Voltage⁽²⁾ ..................... (V–) –0.3V to (V+) +0.3V
Current⁽²⁾ .................................................... 10mA
Output Short-Circuit⁽³⁾ .............................................................. Continuous
Operating Temperature .................................................. –55°C to +125°C
Storage Temperature ..................................................... –55°C to +125°C
Junction Temperature ...................................................................... 150°C
Lead Temperature (soldering, 10s) ................................................. 300°C
ESD Rating:
Charged Device Model, OPA336 NJ and UJ only (CDM)⁽⁴⁾ ....... 1000V
Human Body Model (HBM)⁽⁴⁾ ......................................................... 500V
Machine Model (MM)⁽⁴⁾ .................................................................. 100V
NOTES: (1) Stresses above these ratings may cause permanent damage.
Exposure to absolute maximum conditions for extended periods may
degrade device reliability. These are stress ratings only. Functional opera-
tion of the device at these conditions, or beyond the specified operating
conditions, is not implied. (2) Input terminals are diode-clamped to the power
supply rails. Input signals that can swing more than 0.3V beyond the supply
rails should be current-limited to 10mA or less. (3) Short-circuit to ground,
one amplifier per package. (4) OPA336 NJ and UJ have been tested to CDM
of 1000V. All other previous package versions have been tested using HBM
and MM. Results are shown.
ELECTROSTATIC
DISCHARGE SENSITIVITY
This integrated circuit can be damaged by ESD. Texas
Instruments recommends that all integrated circuits be handled
with appropriate precautions. Failure to observe proper han-
dling and installation procedures can cause damage.
ESD damage can range from subtle performance degrada-
tion to complete device failure. Precision integrated circuits
may be more susceptible to damage because very small
parametric changes could cause the device not to meet its
published specifications.
2
OPA336, 2336, 4336
www.ti.com
SBOS068C