LMV710 Datasheet, PDF (17/20 Pages) National Semiconductor (TI) – Low Power, RRIO Operational Amplifiers with High Output Current Drive and Shutdown Option

Reel Dimensions
10132554
TAPE
SIZE
8 mm
DIM A DIM B
DIM C
DIM D DIM N
DIM W1
7.00 .059
(177.8) (1.5)
.512 + .020/−.008 .795 2.165 .331 + .059/−.000
(13 +0.5/−0.2) (20.2) (55)
(8.4 + 1.5/0)
DIM W2
.567
(14.4)
DIM W3
(LSL-USL)
.311 - .429
(7.9 - 10.9)
Note: UNLESS OTHERWISE SPECIFIED
1. MATERIAL:
POLYSTYRENE/PVC (WITH ANTISTATIC COATING).
OR POLYSTYRENE/PVC, ANTISTATIC
OR POLYSTYRENE/PVC, CONDUCTIVE.
2. CONTROLLING DIMENSION IS MILLIMETER, DIMENSIONS IN
INCHES ROUNDED.
3. SURFACE RESISTIVITY: 10¹⁰ OHM/SQ MAXIMUM.
4. ALL OUTPUT REELS SHALL BE UNIFORM IN SHADE.
5. PACKING OF REELS IN CONTAINERS MUST ENSURE NO
DAMAGE TO THE REEL.
6. SURFACE FINISH OF THE FLANGES SHALL BE SMOOTH,
MATTE FINISH PREFERRED.
7. ALL EDGES, ESPECIALLY THE TAPE ENTRY EDGES, MUST
BE FREE OF BURRS.
8. THE REEL SHOULD NOT WARP IN THE STORAGE TEMPER-
ATURE OF 67°C MAXIMUM.
9. GLASS TRANSITION TEMPERATURE (T_g) OF THE PLASTIC
REEL SHALL BE LOWER THAN −20°C.
10. ALL GATING FROM THE MOLD MUST BE PROPERLY RE-
MOVED.
11. NO FLASHES ARE TO BE PRESENT ALONG THE PARTING
LINES.
12. ALLOWABLE RADIUS FOR CORNERS AND EDGES IS .012
INCHES/0.3 MILLIMETERS MINIMUM.
13. SINK MARKS THAT WILL CAUSE A CHANGE TO THE SPEC-
IFIED DIMENSIONS OR SHAPE OF THE REELS ARE NOT AL-
LOWED.
14. MOLDED REELS SHALL BE FREE OF COSMETIC DEFECTS
SUCH AS VOIDS. FLASHING, EXCESSIVE FLOW MARKS, ETC.
15. THERE MUST BE NO MISMATCH BETWEEN MATING PARTS.
16. MOLDED REELS SHALL BE ANTISTATIC COATED OR
BLENDED.
17. THE SOT23-5L AND SOT23-6L PACKAGE USE THE 7-INCH
REEL.
www.national.com
16