TLC3702-EP_14 Datasheet, PDF (16/31 Pages) Texas Instruments – DUAL MICROPOWER LinCMOS VOLTAGE COMPARATOR

TLC3702ĆEP
DUAL MICROPOWER LinCMOS VOLTAGE COMPARATOR
ą
SGLS127 − JULY 2002
APPLICATION INFORMATION
The inputs should always remain within the supply rails in order to avoid forward biasing the diodes in the
electrostatic discharge (ESD) protection structure. If either input exceeds this range, the device is not damaged
as long as the input is limited to less than 5 mA. To maintain the expected output state, the inputs must remain
within the common-mode range. For example, at 25°C with V_DD = 5 V, both inputs must remain between
−0.2 V and 4 V to ensure proper device operation.
To ensure reliable operation, the supply should be decoupled with a capacitor (0.1 µF) that is positioned as close
to the device as possible.
The TLC3702 has internal ESD-protection circuits that prevent functional failures at voltages up to 2000 V as
tested under MIL-STD-883C, Method 3015.2; however, care should be exercised in handling these devices as
exposure to ESD may result in the degradation of the device parametric performance.
10 kΩ
5V
Table of Applications
Pulse-width-modulated motor speed controller
Enhanced supply supervisor
Two-phase nonoverlapping clock generator
Micropower switching regulator
5V
FIGURE
25
26
27
28
12 V
SN75603
DIR
Half-H Driver
1/2 TLC3702
+
−
10 kΩ
100 kΩ
C1
0.01 µF
(see Note B)
See
Note A
+
−
1/2 TLC3704
EN
12 V
Motor
10 kΩ
DIR
5V
10 kΩ
EN
Motor Speed Control
Potentiometer
5V
Direction
Control
S1
SPDT
SN75604
Half-H Driver
NOTES: A. The recommended minimum capacitance is 10 µF to eliminate common ground switching noise.
B. Adjust C1 for change in oscillator frequency.
Figure 25. Pulse-Width-Modulated Motor Speed Controller
16
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265