BQ24083_16 Datasheet, PDF (14/24 Pages) Texas Instruments – ADJUSTABLE BATTERY VOLTAGE

bq24083
SLUS848A – MAY 2008 – REVISED APRIL 2009 .............................................................................................................................................................. www.ti.com
APPLICATION INFORMATION
bq24083 CHARGER DESIGN EXAMPLE
Requirements
• Supply voltage = 5 V
• Fast-charge current of approximately 750 mA
Calculations
Program the charge current for 750 mA:
R_ISET = [V_(SET) × K_(SET) / I_(OUT)]
From electrical characteristics table, V_(SET) = 2.5 V.
From electrical characteristics table, K_(SET) = 322.
R_ISET = [2.5 V × 322 / 0.75 A] = 1.073 kΩ
Selecting the closest standard value, use a 1.07-kΩ resistor connected between ISET (pin 6) and ground.
STAT Pins and PG Pin
Status pins Monitored by Processor:
Select a pullup resistor that can source more than the input bias (leakage) current of both the processor and
status pins and still provide a logic high. R_PULLUP ≤ [V_(cc-pullup) – V_{(logic hi-min)} / (I_(P-monitor) + I_{(STAT-OpenDrain)}) ] =
(3.3 V – 1.9 V) / (1 µA + 1 µA) ≤ 700 kΩ; Connect a 100-kΩ pullup between each status pin and the V_CC of
the processor. Connect each status pin to a µP monitor pin.
Status viewed by LED:
Select an LED with a current rating less than 10 mA and select a resistor to place in series with the LED to
limit the current to the desired current value (brightness). R_LED = [(V_(IN) – V_(LED-on)) / I_(LED)] = (5 V – 2 V) / 1.5
mA = 2 kΩ. Place an LED and resistor in series between the input and each status pin.
Selecting Input and Output Capacitors
In most applications, all that is needed is a high-frequency decoupling capacitor on the input power pin. A 0.1-µF
ceramic capacitor, placed in close proximity to the IN pin and GND pad works well. In some applications, it may
be necessary to protect against a hot plug input voltage overshoot. This is done in three ways:
1. The best way is to add an input zener, 6.2 V, between the IN pin and VSS.
2. A low-power zener is adequate for the single event transient. Increasing the input capacitance lowers the
characteristic impedance which makes the input resistance move effective at damping the overshoot, but
risks damaging the input contacts by the high inrush current.
3. Placing a resistor in series with the input dampens the overshoot, but causes excess power dissipation.
The device only requires a small capacitor for loop stability. A 0.1-µF ceramic capacitor placed between the OUT
and GND pad is typically sufficient.
14
Submit Documentation Feedback
Product Folder Link(s) :bq24083
Copyright © 2008–2009, Texas Instruments Incorporated