MSP430G2X33_14 Datasheet, PDF (13/71 Pages) Texas Instruments – MIXED SIGNAL MICROCONTROLLER

MSP430G2x33
MSP430G2x03
www.ti.com
Memory Organization
SLAS734F – APRIL 2011 – REVISED MAY 2013
Memory
Main: interrupt vector
Main: code memory
Information memory
RAM
Peripherals
Size
Flash
Flash
Size
Flash
Size
16-bit
8-bit
8-bit SFR
Table 8. Memory Organization
MSP430G2233
MSP430G2203
2kB
0xFFFF to 0xFFC0
0xFFFF to 0xF800
256 Byte
010FFh to 01000h
256 Byte
0x02FF to 0x0200
01FFh to 0100h
0FFh to 010h
0Fh to 00h
MSP430G2333
MSP430G2303
4kB
0xFFFF to 0xFFC0
0xFFFF to 0xF000
256 Byte
010FFh to 01000h
256 Byte
0x02FF to 0x0200
01FFh to 0100h
0FFh to 010h
0Fh to 00h
MSP430G2433
MSP430G2403
8kB
0xFFFF to 0xFFC0
0xFFFF to 0xE000
256 Byte
010FFh to 01000h
512 Byte
0x03FF to 0x0200
01FFh to 0100h
0FFh to 010h
0Fh to 00h
MSP430G2533
16kB
0xFFFF to 0xFFC0
0xFFFF to 0xC000
256 Byte
010FFh to 01000h
512 Byte
0x03FF to 0x0200
01FFh to 0100h
0FFh to 010h
0Fh to 00h
Bootstrap Loader (BSL)
The MSP430 BSL enables users to program the flash memory or RAM using a UART serial interface. Access to
the MSP430 memory via the BSL is protected by user-defined password. For complete description of the
features of the BSL and its implementation, see the MSP430 Programming Via the Bootstrap Loader User's
Guide (SLAU319).
BSL FUNCTION
Data transmit
Data receive
Table 9. BSL Function Pins
20-PIN PW PACKAGE
20-PIN N PACKAGE
3 - P1.1
7 - P1.5
28-PIN PACKAGE PW
3 - P1.1
7 - P1.5
32-PIN PACKAGE RHB
1 - P1.1
5 - P1.5
Flash Memory
The flash memory can be programmed via the Spy-Bi-Wire/JTAG port or in-system by the CPU. The CPU can
perform single-byte and single-word writes to the flash memory. Features of the flash memory include:
• Flash memory has n segments of main memory and four segments of information memory (A to D) of
64 bytes each. Each segment in main memory is 512 bytes in size.
• Segments 0 to n may be erased in one step, or each segment may be individually erased.
• Segments A to D can be erased individually or as a group with segments 0 to n. Segments A to D are also
called information memory.
• Segment A contains calibration data. After reset segment A is protected against programming and erasing. It
can be unlocked but care should be taken not to erase this segment if the device-specific calibration data is
required.
Copyright © 2011–2013, Texas Instruments Incorporated
Submit Documentation Feedback
13