DRV5033_16 Datasheet, PDF (13/28 Pages) Texas Instruments – Digital-Omnipolar-Switch Hall Effect Sensor

www.ti.com
Feature Description (continued)
VCC
DRV5033
SLIS152E – MAY 2014 – REVISED FEBRUARY 2016
t (s)
B (mT)
B_OP
B_RP
t (s)
OUT
Valid Output
t (s)
t_on
t_d
Figure 16. Case 4: Power On When B_RP < B < B_OP, Followed by B < B_RP
7.3.4 Output Stage
The DRV5033 output stage uses an open-drain NMOS, and it is rated to sink up to 30 mA of current. For proper
operation, calculate the value of the pullup resistor R1 using Equation 1.
V_ref max _{d R1 d} V_ref min
30 mA
100 µA
(1)
The size of R1 is a tradeoff between the OUT rise time and the current when OUT is pulled low. A lower current
is generally better, however faster transitions and bandwidth require a smaller resistor for faster switching.
In addition, ensure that the value of R1 > 500 Ω to ensure the output driver can pull the OUT pin close to GND.
NOTE
V_ref is not restricted to V_CC. The allowable voltage range of this pin is specified in the
Absolute Maximum Ratings.
Copyright © 2014–2016, Texas Instruments Incorporated
Product Folder Links: DRV5033
Submit Documentation Feedback
13