SN74LV32A Datasheet, PDF (12/28 Pages) Texas Instruments – Quadruple 2-Input Positive-Or Gates

SN74LV32A
SCLS385K – SEPTEMBER 1997 – REVISED DECEMBER 2014
12 Layout
www.ti.com
12.1 Layout Guidelines
When using multiple bit logic devices, inputs should not float. In many cases, functions or parts of functions of
digital logic devices are unused. Some examples are when only two inputs of a triple-input AND gate are used,
or when only 3 of the 4-buffer gates are used. Such input pins should not be left unconnected because the
undefined voltages at the outside connections result in undefined operational states.
Specified in Figure 7 are rules that must be observed under all circumstances. All unused inputs of digital logic
devices must be connected to a high or low bias to prevent them from floating. The logic level that should be
applied to any particular unused input depends on the function of the device. Generally they will be tied to GND
or V_CC, whichever makes more sense or is more convenient. It is acceptable to float outputs unless the part is a
transceiver. If the transceiver has an output enable pin, it will disable the outputs section of the part when
asserted. This will not disable the input section of the I/Os so they also cannot float when disabled.
12.2 Layout Example
V_cc
Unused Input
Output
Input
Unused Input
Output
Input
Figure 7. Layout Diagram
13 Device and Documentation Support
13.1 Related Links
The table below lists quick access links. Categories include technical documents, support and community
resources, tools and software, and quick access to sample or buy.
PARTS
SN74LV32A
PRODUCT FOLDER
Click here
Table 2. Related Links
SAMPLE & BUY
Click here
TECHNICAL
DOCUMENTS
Click here
TOOLS &
SOFTWARE
Click here
SUPPORT &
COMMUNITY
Click here
13.2 Trademarks
All trademarks are the property of their respective owners.
13.3 Electrostatic Discharge Caution
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam
during storage or handling to prevent electrostatic damage to the MOS gates.
13.4 Glossary
SLYZ022 — TI Glossary.
This glossary lists and explains terms, acronyms, and definitions.
14 Mechanical, Packaging, and Orderable Information
The following pages include mechanical, packaging, and orderable information. This information is the most
current data available for the designated devices. This data is subject to change without notice and revision of
this document. For browser-based versions of this data sheet, refer to the left-hand navigation.
12
Submit Documentation Feedback
Product Folder Links: SN74LV32A
Copyright © 1997–2014, Texas Instruments Incorporated