LM338-MIL Datasheet, PDF (12/28 Pages) Texas Instruments – 5-Amp Adjustable Regulators

LM338-MIL
SNVSAX2 – JUNE 2017
8.2 Typical Applications
8.2.1 Constant 5-V Regulator
TI DEVICE
www.ti.com
Copyright © 2016, Texas Instruments Incorporated
Figure 16. Constant 5-V Regulator
8.2.1.1 Design Requirements
R1: Because the LM338-MIL produces a typical 1.24 V potential between the OUTPUT and ADJUST pins,
placing a 270-Ω resistor between them causes 4.6 mA to flow through R1 and R2.
R2: To achieve a 5-V output, the sum of the voltages across R1 and R2 must equal 5 V. Therefore, Vr2 must
equal 3.76 V when 4.6 mA is flowing through it. R2 = Vr2 / I = 3.76 V / 4.6 mA = ~820 Ω.
C_IN: 0.1 µF of input capacitance helps filter out unwanted noise, especially if the regulator is located far from the
power supply filter capacitors.
C_OUT: The regulator is stable without any output capacitance, but adding a 1-µF capacitor improves the transient
response.
C_ADJ: A 10-µF capacitor bypassing the ADJUST pin to ground improves the regulators ripple rejection.
D1: Protection diode D1 is recommended if C_OUT is used. The diode provides a low-impedance discharge path to
prevent the capacitor from discharging into the output of the regulator (see Protection Diodes).
D2: Protection diode D2 is recommended if C_ADJ is used. The diode provides a low-impedance discharge path to
prevent the capacitor from discharging into the output of the regulator (see Protection Diodes).
Table 1 lists the design parameters for this typical application.
12
Submit Documentation Feedback
Product Folder Links: LM338-MIL
Copyright © 2017, Texas Instruments Incorporated