|
TIBPAL16L8-15M_14 Datasheet, PDF (10/19 Pages) Texas Instruments – HIGH-PERFORMANCE IMPACT | |||
|
◁ |
TIBPAL16L8-15M is Not Recommended for New Designs
TIBPAL16L8-15M, TIBPAL16R4-15M
HIGH-PERFORMANCE IMPACT ⢠PAL® CIRCUITS
SRPS018B â D3338, JANUARY 1986 â REVISED NOVEMBER 2011
electrical characteristics over recommended operating free-air temperature range
TIBPAL16L8-15M
PARAMETER
TEST CONDITIONS
TIBPAL16R6-15M
TIBPAL16R8-15M
MIN TYPâ MAX
UNIT
VIK
VOH
VOL
IOZH
Outputs
I/O ports
VCC = 4.5 V,
VCC = 4.5 V,
VCC = 4.5 V,
VCC = 5.5 V,
II = â 18 mA
IOH = â 2 mA
IOL = 12 mA
VO = 2.7 V
â1.5 V
2.4 3.3
V
0.35 0.5 V
20
100 μA
Outputs
IOZL
I/O ports
VCC = 5.5 V,
VO = 0.4 V
â 20
μA
â 250
Pin 1, 11
II
All others VCC = 5.5 V,
VI = 5.5 V
0.2
mA
0.1
Pin 1, 11
50
IIH
I/O ports VCC = 5.5 V,
All others
VI = 2.7 V
100 μA
20
I/O ports
IIL
All others VCC = 5.5 V,
VI = 0.4 V
â 0.25
mA
â 0.2
IOSâ¡
VCC = 5.5 V,
VO = 0.5 V
â 30
â250 mA
ICC
VCC = 5.5 V,
VI = 0,
Outputs open
170 220 mA
â All typical values are at VCC = 5 V, TA = 25°C.
â¡ Not more than one output should be shorted at a time and the duration of the short circuit should not exceed one second. Set VO at 0.5 V to avoid
test equipment degradation.
switching characteristics over recommended ranges of supply voltage and operating free-air
temperature (unless otherwise noted)
PARAMETER
FROM
(INPUT)
TO
(OUTPUT)
TEST CONDITIONS
MIN TYPâ MAX UNIT
fmax§
tpd
I, I/O
O, I/O
50
MHz
8
15 ns
tpd
CLKâ
Q
R1 = 390 Ω,
7
12 ns
ten
OEâ
Q
R2 = 750 Ω,
8
12 ns
tdis
OEâ
Q
See Figure 1
7
12 ns
ten
I, I/O
O, I/O
8
15 ns
tdis
I, I/O
O, I/O
8
15 ns
â All typical values are at VCC = 5 V, TA = 25°C.
§ Maximum operating frequency and propagation delay are specified for the basic building block. When using feedback, limits must be calculated
accordingly.
10
⢠POST OFFICE BOX 655303 DALLAS, TEXAS 75265
|
▷ |