UCC5628_08 Datasheet, PDF (1/11 Pages) Texas Instruments – MULTIMODE SCSI 14 LINE TERMINATOR

UCC5628
SLUS302C − DECEMBER 1994 − REVISED MARCH 2004
MULTIMODE SCSI 14ĆLINE TERMINATOR
FEATURES
D Auto Selection Single Ended (SE) or Low
Voltage Differential (LVD) Termination
D Meets SCSI−1, SCSI−2, SCSI−3, SPI, Ultra
(Fast−20), Ultra2 (SPI−2 LVD), Ultra3, Ultra160
(SPI−3) and Ultra320 (SPI−4) Standards
D 2.7V to 5.25V Operation
D Differential Failsafe Bias
D Thermal packaging for low junction
temperature and better MTBF
DESCRIPTION
The UCC5628 Multimode SCSI terminator provides a
smooth transition into the low-voltage differential SCSI
parallel interface (SPI−2, SPI−3 and SPI−4). It
automatically senses the bus, via DIFFB, and switches
the termination to either single ended (SE) or
low-voltage differential (LVD) SCSI, dependent on
which type of devices are connected to the bus. The
UCC5628 can not be used on a high voltage differential
(HVD), EIA485, differential SCSI bus. If the UCC5628
detects a HVD SCSI device, it switches to a
high-impedance state.
BLOCK DIAGRAM
2.15V
DIFFB 34
HPD
(NOISE LOAD)
−15 mA ≤ ISOURCE ≤ −5 mA
50 µA ≤ ISINK ≤ 200 µA
REF
1.3V
1.3V
ENABLE
35 DIFFSENS
27 LVD
0.6V
REF
2.7V
REF
1.25V
SOURCE/SINK REGULATOR
110 Ω
124 Ω
56mV
−+
56mV
+−
52.5 Ω
52.5 Ω
26 SE
12 L1−
11 L1+
DISCNCT 36
10µA
ENABLE
TRMPWR 3
MODE
SE
LVD
DISCNCT
ALL SWITCHES
UP
DOWN
OPEN
25
GND
4−9
HS/GND
28−33
HS/GND
10
REG
110 Ω
SE GND SWITCH
124 Ω
56mV
−+
56mV
+−
52.5 Ω
52.5 Ω
SE GND SWITCH
2 L14−
1 L14+
UDG−98099
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam
during storage or handling to prevent electrostatic damage to the MOS gates.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
www.ti.com
Copyright  2003, Texas Instruments Incorporated
1