UCC28180 Datasheet, PDF (1/48 Pages) Texas Instruments – Programmable Frequency, Continuous Conduction Mode (CCM), Boost Power Factor Correction (PFC) Controller

www.ti.com
UCC28180
SLUSBQ5A – NOVEMBER 2013 – REVISED NOVEMBER 2013
Programmable Frequency, Continuous Conduction Mode (CCM), Boost Power Factor
Correction (PFC) Controller
Check for Samples: UCC28180
FEATURES
1
• 8-pin Solution (no AC line sensing needed)
• Wide Range Programmable Switching
Frequency (18 kHz to 250 kHz for MOSFET and
IGBT based PFC converters)
• Trimmed Current Loop Circuits for Low iTHD
• Reduced Current Sense Threshold (minimizes
power dissipation in shunt)
• Average Current-Mode Control
• Soft Over Current and Cycle-by-Cycle Peak
Current Limit Protection
• Output Over-Voltage Protection with
Hysteresis Recovery
• Audible Noise Minimization Circuitry
• Open Loop Detection
• Enhance Dynamic Response During Output
Over and Under-Voltage Conditions
• Maximum Duty Cycle of 96% (typical)
• Burst Mode for No Load Regulation
• VCC UVLO, Low ICC Start-Up (<75 µA)
APPLICATIONS
• Universal AC Input, CCM Boost PFC
converters in 100-W to Few-kW range
• Server and Desktop Power Supplies
• White Good Appliances (Air Conditioners,
Refrigerators)
• Industrial Power Supplies (DIN Rail)
• Flat Panel TV (PDP, LCD and LED) TVs
DESCRIPTION
The UCC28180 is a flexible and easy-to-use, 8-pin,
active Power Factor Correction (PFC) controller that
operates under Continuous Conduction Mode (CCM)
to achieve high Power Factor, low current distortion
and excellent voltage regulation of boost pre-
regulators in AC - DC front-ends. The controller is
suitable for universal AC input systems operating in
100-W to few-kW range with the switching frequency
programmable between 18 kHz to 250 kHz, to
conveniently support both power MOSFET and IGBT
switches. An integrated 1.5-A and 2-A (SRC-SNK)
peak gate drive output, clamped internally at 15.2 V
(typical), enables fast turn-on, turn-off and easy
management of the external power switch without the
need for buffer circuits.
Low-distortion wave shaping of the input current
using average current mode control is achieved
without input line sensing, reducing the external
component count. In addition, the controller features
reduced current sense thresholds to facilitate the use
of small value shunt resistors for reduced power
dissipation, especially important in high power
systems. To enable low current distortion, the
controller also features trimmed internal current loop
regulation circuits for eliminating associated
inaccuracies.
Typical Application
LINE
INPUT
EMI Filter
– + Bridge
Rectifier
1 GND
GATE 8
2 ICOMP
VCC 7
3 ISENSE VSENSE 6
4 FREQ VCOMP 5
UCC28180
Auxilary
Supply
VOUT
Rload
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2013, Texas Instruments Incorporated