TUSB6010B Datasheet, PDF (1/7 Pages) Texas Instruments – USB2.0 High Speed (HS) On-the-Go (OTG) Dual Role Controller

TUSB6010BZQE, TUSB6010BIZQE
www.ti.com
www.ti.com
SLLA269 – OCTOBER 2007
USB2.0 High Speed (HS) On-the-Go (OTG) Dual Role Controller
FEATURES
1
• USB 2.0 HS OTG Dual Role Controller Core
– Act as a USB 2.0 HS Peripheral
– Act as a USB 2.0 HS Embedded Host
Controller
– Act as a USB 2.0 HS OTG Device
– Supports Session Request Protocol
(SRP)
– Supports Host Negotiation Protocol
(HNP)
• Integrated USB 2.0 OTG PHY
• NOR FLASH - Like External Host Interface
• Configurable for up to 15 transmit endpoints
and up to 15 receive endpoints
– 16 kilobyte RAM for USB endpoint FIFO
shared by USB IN/OUT endpoints
– Configurable FIFOs, including the option of
dynamic FIFO sizing
– Support for external DMA access to FIFOs
• Power Management Module
– Ultra low power Idle mode for battery
conscious applications
– Support for External Charge Pump
• TUSB6010BZQE/TUSB6010BIZQE are RoHS
compliant.
• 80 Terminal BGA Microstar Junior Package
DESCRIPTION
The TUSB6010B is a USB 2.0 HS Dual Role USB Controller designed for seamless interface to an external Host
processor through the NOR FLASH-like interface. The TUSB6010B can be used to enable the processor to
implement any one of three genral types of USB devices. It can be implemented as a USB high-speed peripheral
(or target), as a USB high-speed, single-port, embedded host controller, or as a USB high-speed OTG device.
Software on the application processor will be required to implement the chosen type of USB device.
The NOR FLASH-like interface is a multiplexed, 16-bit interface with support for burst and single read/write
access. It can operate in both synchronous and asynchronous modes.
The Power Management Module provides external USB OTG Charge Pump control through the power
control/status interface. The Power Management Module provides a seamless interface to the TPS65030 Power
Management IC for USB-OTG.
The device also has eight user configurable general purpose I/0 interface pins. The GPIO can be configured as
an interrupt or wakeup source. Some GPIO have secondary NOR-flash DMA Request functionality.
The device is fully compliant with the Universal Serial Bus Specification Rev. 2.0 and On-The-Go Supplement to
the USB Specification Rev. 1.3.
The ESD protection level is 2KV HBM (JESD22-A114D), 500V CDM (JESD22-C101C).
NOTE:
This product is intended for high-volume handset applications only. Contact
[e-mail] for more information.
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
Submit Documentation Feedback
Copyright © 2007, Texas Instruments Incorporated