English
Language : 

TPS715_17 Datasheet, PDF (1/22 Pages) Texas Instruments – 50-mA, 24-V, 3.2-uA Supply Current Low-Dropout Linear Regulator in SC70 Package
Product
Folder
Sample &
Buy
Technical
Documents
Tools &
Software
Support &
Community
TPS715
SLVS338R – MAY 2001 – REVISED APRIL 2015
TPS715 50-mA, 24-V, 3.2-μA Supply Current Low-Dropout Linear Regulator
in SC70 Package
1 Features
•1 24-V Maximum Input Voltage
• Low 3.2-μA Quiescent Current at 50 mA
• Stable With Any Capacitor ≥ 0.47 μF
• 50-mA Low-Dropout Regulator
• Available in 1.8 V, 1.9 V, 2.3 V, 2.5 V, 3 V,
3.3 V, 3.45 V, 5 V, and
Adjustable (1.2 V to 15 V)
• Designed to Support MSP430 Families:
– 1.9-V Version Ensured to be Higher Than
Minimum VIN of 1.8 V
– 2.3-V Version Ensured to Meet 2.2-V Minimum
VIN for Flash on MSP430F2xx
– 3.45-V Version Ensured to be Lower Than
Maximum VIN of 3.6 V
– Wide Variety of Fixed-Output Voltage Options
to Match VIN to the Minimum Required for
Desired MSP430 Speed
• Minimum and Maximum Specified Current Limit
• 5-Pin SC70 (DCK)
• –40°C to +125°C Specified Junction
Temperature Range
• For 80-mA Rated Current and Higher Power
Package, see TPS715A
3 Description
The TPS715 low-dropout (LDO) voltage regulators
offer the benefits of high input voltage, low-dropout
voltage, low-power operation, and miniaturized
packaging. The devices, which operate over an input
range of 2.5 V to 24 V, are stable with any capacitor
greater than or equal to 0.47 μF. The low dropout
voltage and low quiescent current allow operation at
extremely low power levels. Therefore, the devices
are ideal for powering battery management ICs.
Specifically, because the devices are enabled as
soon as the applied voltage reaches the minimum
input voltage, the output is quickly available to power
continuously operating battery charging ICs.
The usual PNP pass transistor has been replaced by
a PMOS pass element. Because the PMOS pass
element behaves as a low-value resistor, the low
dropout voltage, typically 415 mV at 50 mA of load
current, is directly proportional to the load current.
The low quiescent current (3.2 µA typically) is stable
over the entire range of output load current (0 mA to
50 mA).
Device Information(1)
PART NUMBER
PACKAGE
BODY SIZE (NOM)
TPS715
SC70 (5)
2.00 mm × 1.25 mm
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
2 Applications
• Ultralow Power Microcontrollers
• Cellular and Cordless Handsets
• Portable and Battery-Powered Equipment
Typical Application Schematic
Solar
Cell
TPS715xx
IN
OUT
GND
MSP430
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.