|
TPS65185_17 Datasheet, PDF (1/61 Pages) Texas Instruments – PMIC for E Ink Vizplex Enabled Electronic Paper Display | |||
|
Product
Folder
Order
Now
Technical
Documents
Tools &
Software
Support &
Community
TPS65185, TPS651851
SLVSAQ8E â FEBRUARY 2011 â REVISED FEBRUARY 2017
TPS65185x PMIC for E Ink® Vizplex⢠Enabled Electronic Paper Display
1 Features
â¢1 Single Chip Power-Management Solution for
E Ink® Vizplex⢠Electronic Paper (E-Paper)
Displays
⢠Generates Positive and Negative Gates, and
Source Driver Voltages and Back-Plane Bias
From a Single, Low-Voltage Input Supply
⢠Supports 9.7-Inch and Larger Panel Sizes
⢠3-V to 6-V Input Voltage Range
⢠Boost Converter for Positive Rail Base
⢠Inverting Buck-Boost Converter for Negative Rail
Base
⢠Two Adjustable LDOs for Source Driver Supply
â TPS65185 LDO1: 15 V, 120 mA (VPOS)
â TPS65185 LDO2: â15 V, 120 mA (VNEG)
â TPS651851 LDO1: 15 V, 200 mA at
VIN⥠3.6 V (VPOS)
â TPS651851 LDO2: â15 V, 200 mA at
VIN⥠3.6 V (VNEG)
⢠Accurate Output Voltage Tracking
â VPOS â VNEG = ±50 mV
⢠Two Charge Pumps for Gate Driver Supply
â CP1: 22 V, 15 mA (VDDH)
â CP2: â20 V, 15 mA, (VEE)
⢠Adjustable VCOM Driver for Accurate Panel-
Backplane Biasing
â 0 V to â5.11 V
â ± 1.5% accuracy (±10 mV)
â 9-Bit Control (10-mV Nominal Step Size)
⢠Active Discharge on All Rails
⢠Integrated 10-Ω, 3.3-V Power Switch for Disabling
System Power Rail to E-Ink Panel
2 Applications
⢠Power Supply for Active Matrix E Ink Vizplex
Panels
⢠Electronic Paper Display (EPD) Power Supplies
⢠E-Book Readers
⢠Dual-Display Phone and Tablets
⢠Application Processors With Integrated or
Software Timing Controller (OMAPâ¢)
3 Description
The TPS65185x device is a single-chip power supply
designed to for E Ink Vizplex displays used in
portable e-reader applications, and the device
supports panel sizes up to 9.7 inches and greater.
Two high efficiency DC-DC boost converters
generate ±16-V rails that are boosted to 22 V and
â20 V by two change pumps to provide the gate
driver supply for the Vizplex panel. Two tracking
LDOs create the ±15-V source driver supplies that
support up to 120/200 mA (TPS65185/TPS651851) of
output current. All rails are adjustable through the I2C
interface to accommodate specific panel
requirements.
Device Information(1)
PART NUMBER
PACKAGE
BODY SIZE (NOM)
TPS65185
RGZ (48)
RSL (48)
7.00 mm à 7.00 mm
6.00 mm à 6.00 mm
TPS651851
RSL (48)
6.00 mm à 6.00 mm
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
From Input
Supply
(3 V to 6 V)
From Input
Supply
(3 V to 6 V)
Typical Application Schematic
VIN
TS
VN_SW
VN
VB_SW
VB
Temperature
Sensor
DCDC2
DCDC1
Positive
Charge
Pump
LDO1
VCOM
LDO2
VDDH_D
VDDH_DRV
VDDH_FB
VPOS
VCOM
VCOM_PANEL
VNEG
I/O
Control
VCOM
Negative
Charge
Pump
VEE_D
VEE_DRV
VEE_FB
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.
|
▷ |