TPS650842 Datasheet, PDF (1/7 Pages) Texas Instruments – PMIC for Intel Braswell Platform

Product
Folder
Sample &
Buy
Technical
Documents
Tools &
Software
Support &
Community
TPS650842 PMIC for Intel Braswell Platform
TPS650842
SWCS132 – AUGUST 2015
1 Device Overview
1.1 Features
1
• Three Variable-Output Voltage Step-Down
Controllers
– Wide V_IN Range From 5.4 V to 21 V
– Up to 7-A Output Current for BUCK1 (VCC) and
BUCK6 (VDDQ), and 11-A for BUCK2 (VGG)
Using External FETs
– I²C DVS Control (0.5 V to 1.45 V in 10-mV
Steps) for BUCK1 and BUCK2
– Pin-Selectable Dual Output Voltages (1.2 V or
1.35 V) for BUCK6 (VDDQ)
• Three Variable-Output Voltage Synchronous Step-
Down Converters
– V_IN Range From 4.5 V to 5.5 V
– Up to 3.5 A of Output Current for BUCK3 (VNN)
With I²C DVS Control (0.65 V to
1.45 V in 25-mV Steps)
– Up to 3 A of Output Current for BUCK4
(V1P05A) and up to 1.5 A of Output Current for
BUCK5 (V1P8A)
• Three LDO Regulators With Adjustable Output
Voltage
– LDOA1: I²C-Selectable Output Voltage From
1.35 V to 3.3 V for up to 200 mA of Output
Current
– LDOA2: I²C-Selectable Output Voltage From
1.05 V, 1.1 V, 1.15 V, and 1.2 V
– LDOA3: I²C-Selectable Output Voltage From
1.1 V, 1.15 V, 1.2 V, and 1.24 V
• VTT LDO for DDR3 and DDR4 Memory
Termination
• Three Load Switches With Slew Rate Control
– Up to 300 mA of Output Current With Voltage
Drop Less Than 1.5% of Nominal Input Voltage
– R_DSON < 96 mΩ at Input Voltage of 1.8 V
• I²C Interface (Device Address 0x5E) Supports
Standard Mode (100 kHz), Fast Mode (400 kHz),
and Fast Mode Plus (1 MHz)
• 64-Pin, Single-Row, 0.4-mm Pitch QFN Package
1.2 Applications
• 2-, 3-, or 4-Series Cell Li-Ion Battery Powered
Products (NVDC or Non-NVDC)
• Tablet, Ultrabook, and Notebook Computers
• Mobile PCs and Mobile Internet Devices
1.3 Description
The TPS650842 device is a single-chip solution, power-management IC designed specifically for the latest
Intel™ processors targeted for tablets, ultrabooks, and notebooks with NVDC or non-NVDC power
architectures, using 2S, 3S, or 4S Li-Ion battery packs. The TPS650842 device is used for essential
systems with low-voltage rails merged for the smallest footprint and lowest-cost system-power solution.
The TPS650842 device provides the complete power solution based on the Intel Reference Designs. Six
highly efficient step-down voltage regulators (VRs), a sink or source LDO (VTT), two LDOs, and three load
switches are controlled by power-up sequence logic to provide the proper power rails, sequencing, and
protection—including DDR3 and DDR4 memory power. The three regulators (BUCK1–BUCK3) support
dynamic voltage scaling (DVS) for maximum efficiency—including support for Connected Standby. The
high-frequency VRs use small inductors and capacitors to achieve a small solution size. An I²C interface
allows simple control by an embedded controller (EC) or by a system on chip (SoC). The PMIC comes in
an 8-mm × 8-mm single-row QFN package with a thermal pad for good thermal dissipation and ease of
board routing.
Use the following email address to request the full version of this data sheet: [e-mail].
PART NUMBER
TPS650842
Device Information
PACKAGE
RSK (64)
BODY SIZE (NOM)
8.00 mm × 8.00 mm
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.