TPS54311-Q1 Datasheet, PDF (1/20 Pages) Texas Instruments – 3-V TO 6-V INPUT, 3-A OUTPUT SYNCHRONOUS-BUCK PWM SWITCHER WITH INTEGRATED FETs

Obsolete Devices:
TPS54314-Q1 and TPS54315-Q1
www.ti.com
Typical Size
(6,3 mm x 6,4 mm)
TPS54311-Q1, TPS54312-Q1
TPS54313-Q1, TPS54314-Q1
TPS54315-Q1, TPS54316-Q1
SGLS242G − OCTOBER 2004 − REVISED SEPTEMBER 2008
3-V TO 6-V INPUT, 3-A OUTPUT SYNCHRONOUS-BUCK PWM
SWITCHER WITH INTEGRATED FETs (SWIFT)
FEATURES
D Qualified for Automotive Applications
D 60-mΩ MOSFET Switches for High Efficiency
at 3-A Continuous Output Source or Sink
Current
D 0.9-V, 1.2-V, 1.5-V, 1.8-V, 2.5-V, and 3.3-V Fixed
Output Voltage Devices With 1% Initial
Accuracy
D Internally Compensated for Low Parts Count
D Fast Transient Response
D Wide PWM Frequency: Fixed 350 kHz,
550 kHz, or Adjustable 280 kHz to 700 kHz
D Load Protected by Peak Current Limit and
Thermal Shutdown
D Integrated Solution Reduces Board Area and
Total Cost
APPLICATIONS
D Low-Voltage, High-Density Systems With
Power Distributed at 5 V or 3.3 V
D Point of Load Regulation for High
Performance DSPs, FPGAs, ASICs, and
Microprocessors
D Broadband, Networking and Optical
Communications Infrastructure
D Automotive Telematics
DESCRIPTION
As members of the SWIFT family of dc/dc regulators, the
TPS54311, TPS54312, TPS54313, TPS54314,
TPS54315, and TPS54316 low-input-voltage high-output
current synchronous-buck PWM converters integrate all
required active components. Included on the substrate
with the listed features are a true, high performance,
voltage error amplifier that provides high performance
under transient conditions; an undervoltage-lockout circuit
to prevent start-up until the input voltage reaches 3 V; an
internally and externally set slow-start circuit to limit
in-rush currents; and a power good output useful for
processor/logic reset, fault signaling, and supply
sequencing.
The TPS54311, TPS54312, TPS54313, TPS54314,
TPS54315, and TPS54316 devices are available in a
thermally enhanced 20-pin TSSOP (PWP) PowerPAD
package, which eliminates bulky heatsinks. Texas
Instruments provides evaluation modules and the SWIFT
designer software tool to aid in quickly achieving
high-performance power supply designs to meet
aggressive equipment development cycles.
These devices have limited built-in ESD protection. The leads should be shorted together or the device placed in conductive foam during
storage or handling to prevent electrostatic damage to the MOS gates.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas Instruments
semiconductor products and disclaimers thereto appears at the end of this data sheet.
PowerPAD and SWIFT are trademarks of Texas Instruments.
PRODUCTION DATA information is current as of publication date. Products
conform to specifications per the terms of Texas Instruments standard warranty.
Production processing does not necessarily include testing of all parameters.
Copyright  2008, Texas Instruments Incorporated