TPS2066-Q1 Datasheet, PDF (1/24 Pages) Texas Instruments – CURRENT-LIMITED, POWER-DISTRIBUTION SWITCH

TPS2066-Q1
www.ti.com
SLVSB37 – SEPTEMBER 2011
CURRENT-LIMITED, POWER-DISTRIBUTION SWITCH
Check for Samples: TPS2066-Q1
FEATURES
1
•2 Qualified for Automotive Applications
• 70-mΩ High-Side MOSFET
• 1-A Continuous Current
• Thermal and Short-Circuit Protection
• Accurate Current Limit
(1.1 A min, 1.9 A max)
• Operating Range: 2.7 V to 5.5 V
• 0.6-ms Typical Rise Time
• Undervoltage Lockout
• Deglitched Fault Report (OC)
• No OC Glitch During Power Up
• 1-μA Maximum Standby Supply Current
• Bidirectional Switch
• Ambient Temperature Range: -40°C to 105°C
• Built-in Soft-Start
• UL Listed - File No. E169910
APPLICATIONS
• Heavy Capacitive Loads
• Short-Circuit Protections
DGN PACKAGE
(TOP VIEW)
All enable inputs are active high
DESCRIPTION
The TPS2066-Q1 power-distribution switch is intended for applications where heavy capacitive loads and
short-circuits are likely to be encountered. This device incorporates 70-mΩ N-channel MOSFET power switches
for power-distribution systems that require multiple power switches in a single package. Each switch is controlled
by a logic enable input. Gate drive is provided by an internal charge pump designed to control the power-switch
rise times and fall times to minimize current surges during switching. The charge pump requires no external
components and allows operation from supplies as low as 2.7 V.
When the output load exceeds the current-limit threshold or a short is present, the device limits the output current
to a safe level by switching into a constant-current mode, pulling the overcurrent (OCx) logic output low. When
continuous heavy overloads and short-circuits increase the power dissipation in the switch, causing the junction
temperature to rise, a thermal protection circuit shuts off the switch to prevent damage. Recovery from a thermal
shutdown is automatic once the device has cooled sufficiently. Internal circuitry ensures that the switch remains
off until valid input voltage is present. This power-distribution switch is designed to set current limit at 1.5 A
typically.
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PowerPAD is a trademark of Texas Instruments.
2
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2011, Texas Instruments Incorporated